1/4" of warp allowed in a 12 inch span measured anywhere on the sheet.
This information is found in Tappi standard "TIP 0304-13, Statistical process control - procedures for charting warp".
Easiest way to test is to use a 12 inch steel rule and lay it on your sheet, if the gap between the sheet and the rule is less that 1/4" it is typically within Tappi standards.
With todays high speed converting machinery this is no longer an exceptable standard in many manufacturing facilities, especially for high graphics print jobs.
/setwarp (name of warp)
no,actually there is such thing as a time warp
Take the only warp square.Take the bottom-left warp square.Take the bottom-left warp square again.Take the top-right warp square.Take the bottom-left warp square.You should be in the gym leader's room.(instructions from pokedream.com)
Lilycove City Warp Gameshark Code: EF6C4684 7B994DBB
1. Take the only warp square. 2. Take the bottom-left warp square. 3. Take the bottom-left warp square again. 4. Take the top-right warp square. 5. Take the bottom-left warp square. 6. You should be in the gym leader's room.
One can measure Cobb of kraft paper in lab following TAPPI T441 standard.
Technical association of paper n pulp industry
/setwarp (name of warp)
No, it cannot warp metal.
A warp scarf randomly warps the holder
no,actually there is such thing as a time warp
The past tense of warp is warped.
WaRP Graphics was created in 1977.
Warp Brothers was created in 1999.
Delta Warp happened in 2000.
Mind Warp was created in 1982.
Space Warp was created in 1983.