It changes the model. Say you are making a new top or a new pair of pants you could change the person that the pants were on.
Just click on the mannequin and press the down arrow key.
you press the plus button located on the Wii remote and go to edit lines and press the right or left button until you get to the goalie change spot
press 'command' if i were you, i change the minecraft settings so you need to press the button 'c' to place blocks
Smash it with a hammer.
Don't press the big red button! For the good of all humanity- don't even think about pressing the button!*Presses button*False alarm. It was the big green button you weren't supposed to press.*Presses big green button*NOOOOO!
With the radio off, press the "set" button. Then press the "scan" button to change the hour and the "seek" button to change the minutes. Once the time is correct press the "set" button once more to change the time.
Press and hold the Clk button. While holding the Clk button down, press the Seek button to change the hour and press the Tune button the change the miutes.
Just click on the mannequin and press the down arrow key.
Press the MODE button 3 times. Press the LAP/RESET button until the hour flashes. Press the ST./STOP button to change the hour. Press the LAP/RESET button again to select the minutes. Press the ST./STOP button to change the minutes. Press MODE again when you're finished setting the time.
Press the mode button to get the time you want to change on the display. The press and hold the reset button until the seconds begin to flash>press the stop/start button to reset the seconds >press mode button to get hours to flash>press the st/stp button to advance the hours > press the reset button to get minutes to flash>advance minutes with st/stp button >press reset button to get date to flash > press st/stp button to advance date >when all time and date are set press mode to return to normal time display
Hold the adjust button then click the mode button until you see the (wrong) time. Then to change the numbers just keep clicking the split.reset button. You can also change the date and day by doing one at a time. To set the time, date, or day of the week press start.stop.
you press the E button.
Hold the reset button and when the time starts to blink push the st/stp button which will change the time and press the mode button to change from hour to min. Press the reset button to save it .
Press and hold clock button as your press seek arrow buttons for hour change. For minutes press and hold clock button as your press tune disc button.
Click on it and press up
Press & hold the AMB button, then while holding the AMB button in press the Temp down button for at least 3 seconds and display will change.
1 Press and Hold the RESET button until screen flashes 2 Press MODE button until segment you wish to change is flashing 3 Press START/STOP button to change segment 4 Press RESET to exit programming mode