Lead is unlikely to become airborne during hand soldering because the operation occurs at a temperature much lower than the boiling point of the lead.
mucus
Fugula
jes PC
One of the secret weapons in Medal of Honor: Airborne is the C96 Mauser hidden in the control room on Operation Varsity. Another is the BAR which can be found by the ammo drop in Operation Market Garden.
Of course it has blood, it's a war game. The blood however is not gratuitous.
lead burning or lap joint soldering
In batteries and soldering.
solder tin, lead,
Lead "burning, Soldering with the use of lap joints
false
Since question is not clear two answers can be given on the assumption that the question is about dry soldering. Thoroughly clean the part to be soldered, apply flux re-solder the connection. The second answer is normally lead will not be kept on a soldering point. the technician doing soldering has to use lead and flux separately. ================================ There are still solders that contain lead. The European Union prohibited excessive amounts of lead in consumer products (WEEE and RoHS), so there are lead-free solders. But there are industries in which the lead-free solders are not acceptable.
Have you ever had a soldering iron roll off the table and land on your wrist, burning a hole that took over a month to heal? I did in 5th grade while building one of the Radio Shack electronics kits I had received for Christmas! Learning from that I made my own soldering stand from a small metal can and poured over a half inch of lead into the bottom from my lead soldier casting set to make sure that the weight of the soldering iron could not tilt the soldering stand!!! I was never going to run the risk of a soldering iron getting away from me again!!!!!
Soldering irons are usually used with rosin core solder. Sometimes it has lead in it but often not since its toxic. Most of the time its for heavy soldering like heavy gauge wires or older circuit boards since the tips are fairly big. They also have a decent temperature control so anything that is delicate like large SMD soldering.
Because it melts easily and is good in a solder mixture to hold wires together.
Soldering and brazing both join two parts by melting a different metal as an adhesive without damaging the two parts being joined. Soldering uses a different metal that has a lower melting point (usually lead-based) than the metal used in brazing (usually silver). This allows easier joining in soldering, but a stronger bond in brazing.
why do you think its best for soldering iron to have soldering stand
There are a number of different alloys that can be used as joiner alloys in soldering. Which one you choose would depend on which metals you want to join and whether you want your joiner alloy to be lead-free or not.