answersLogoWhite

0


Best Answer

The Big Culvert was created in 1870.

User Avatar

Wiki User

10y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: When was The Big Culvert created?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

When was Thorpe Culvert railway station created?

Thorpe Culvert railway station was created in 1871.


When was Old Enon Road Stone Arch Culvert created?

Old Enon Road Stone Arch Culvert was created in 1871.


What are the types of culvert?

1. Pepe culvert 2. box culvert 3. slab culvert 4. arch culvert


What is a sentence of culvert?

The fox is in the culvert. The culvert is blocked at the other end.


What is a CMP culvert?

Corrugate Metal Pipe Culvert.


How do you use the word culvert in a sentence?

There is enough room to put a navigable culvert through this side.


What does culvert mean?

Culvert isa tunnelwhich channelsa stream or open drain under a road or railroad.


What is the invert level of a culvert?

it is the elevation at the bottom of the inside of a pipe (as if there was a drop of water sitting at the bottom) which typically dumps out of a culvert, or spillway


Do you get a free drop from a culvert?

You can install a culvert such as this one, which carries overflow. For one week, BuildingGreen is offering a free download of an insulation.


What is box culvert?

Box culvert can be described as either a precast concrete or reinforced concrete structure in rectangular figure, facilitating water flow through an embankment of road,etc,as a similar function performed by concrete pipe culvert.


How do you installs culverts?

" Step 1 Dig out the drainage ditch. Broaden the ditch to roughly twice the width of the culvert and angle the sides of the ditch. Dig about six inches out of the bottom, for the entire length of the culvert. Step 2 Fill the bottom six inches with gravel, maintaining the original level of the drainage ditch. The gravel will allow the culvert to settle evenly and allow for better drainage in the event that water flows around the culvert. Step 3 Place the culvert in the ditch, centering it in the gravel. There should be about one foot of excess length on each end of the culvert. Step 4 Fill in the sides next to the culvert with dirt, tamping the dirt down at regular intervals. Keep the culvert centered in the ditch while doing this; a crooked culvert will cause erosion on the walls of the ditch. Step 5 Cover the top of the culvert. Cover with at least 12 inches of dirt and tamp down well. Cover this with gravel to avoid erosion. Step 6 Tamp the sides of the fill down tightly, making sure they are angled in towards the top. Regular maintenance will be needed to keep the walls from eroding away." and that how u install it


What rhymes with pervert?

introvert, subvert, culvert, extrovert