0
Add your answer:
Earn +20 pts
What is the double of rip?
A Rip has a few meanings but a common meaning is a Rip as in the ocean rip.
What is the default parental control pin for comcast?
There is no default pin. The default is 'not programmed'.
When did Rip Vowinkel die?
Rip Vowinkel died on 1966-07-13.
What is Rip Rogers's birthday?
Rip Rogers was born on February 14, 1955.
When did Rip Sewell die?
Rip Sewell died on 1989-09-03.
What is the default administrative value of rip?
120
What is the administrative distance of a default route?
The administrative distance of a default route is typically 1. This means that it is considered the most reliable and preferred route for forwarding traffic when no other more specific route is available in the routing table.
Show ip route command?
Compared to RIP, EIGRP has a lower administrative distance.
Which routing protocol has the most trustworthy administrative distance by default?
generally static routing protocol has the most trustworthy administrative distance .i.e; 1 and in dynamic routing protocols EIGRP has the best AD.
Why is the show ip route command important for troubleshooting commands?
Compared to RIP, EIGRP has a lower administrative distance. Compared to EIGRP, RIP has a higher metric value for the route. Compared to RIP, the EIGRP route has fewer hops. Compared to RIP, EIGRP has a faster update timer.
How often does RIP broadcast routing updates?
Every 30 seconds by default in RIP version 1.
What command is used with RIP to propagate default routes to neighbors?
ip default-network address
What the administrative distance and metric for static route?
The administrative distance for a static route is typically 1, meaning it is very reliable and preferred over routes learned from dynamic routing protocols. The metric for a static route is typically one hop, meaning it has a fixed cost regardless of network conditions or traffic load.
Which command shows the administrative distance of routes?
what command allows you to configure an administrative distance
When is it possible to use administrative shares?
To use administrative shares you have to belong to a domain. Administrative shares only work on a domain and are default settings.
Is it possible to use RIP V1 with default static routes?
At the foundrynet website there is detailed information on default static routes and instructions on how to activate RIP V1 defaults.Also, information on switching and routing.
What is the default value of the RIP hold-down timer?
180 seconds
