sorta a little bit i would say . but it holds an edge great
and the rust is not a giant amount because it is a semi stainless steel
just barley not stainless.
no R2 D2 is a fictional astromechdroid robot from the Star Wars movies played by Kenny Baker Altough R2 D2 is not real ,real robots of it made by fans exist.
R2-D2 was the small robot that carried the plea for help by Princess Leia and was discovered by Luke Sykwalker in the first movie(4th in series).
R2-D2 and C-3PO were walking around the desert, arguing , when they got kidnapped by Jawas. (To be sold)
yes the gayest! C3PO declared his love for R2-D2 in Episode 2. He then proceeded with his love and later on married R2-D2 in the ficitional episode 7.
its so much fun, playin the can-can. capital letters are half notes, lowercase are quarter notes. equal signs (=) are rests. here goes: D D d1 d3 d2 d1 A0 A0 a0 a1 d2 d3 D1 D1 d1 d3 d2 d1 d0 a3 a2 a1 a0 d3 d2 d1 D0 D0 d1 d3 d2 d1 A0 A0 a0 a1 d2 d3 D1 D1 d1 d3 d2 d1 d0 a0 d1 d2 d0
D2 tool steel is a steel, tool steel. For cold rolled steel, D2.
steel will rust when you wash it
Yes, D-2 is a high carbon tool steel. D-2 tool steel has about 1.55% carbon in its chemical composition. Any grade of tool steel with more than 0.5% carbon is generally considered to be a high carbon tool steel. Tool steel needs to have a minimum of .4% carbon to harden properly. For more information on tool steels, their properties and alloying element, please see the related link.
it rusts
steel rusts
A katana made of that particular steel will be difficult to find. D2 is hard to work, has a fairly complex heat treating cycle and is near impossible to get a good finish on it. So I really have no idea who would make one.
stainless steel
D-2 is a tool steel that is supplied in the annealed or soft condition. This grade must be hardened after machining . D-2 is heat treated between 1825 to 1875F. After heat treating, the tool steel will attain a hardness of about RC 62-64. However, after hea treating, the steel is very brittle and must be tempered. Below is a list of common temperatures for D2 try this......Tempering °C150200250300350400HRc62/6161/6060/5957/5656/5556/55See the related links for the D-2 tool steel data sheet and an introduction to the heat treating process.
Yes, steel rusts and over time it will decay.
steel rusts fastest in salt water.. wonder why??? because salt water has sodium which can react to iron in steel.
D2/162
Steel oxidises fastest