0
Add your answer:
Earn +20 pts
Why is hot air blasted into a blast furnace?
Hot air is blasted into the blast furnace to burn the coke (a cheap form of carbon) added to form carbon dioxide.
How do you think the blast furnace got its name?
the blast furnace got its name , because its bottom which is called a furnace blows hot air to go up.
What is air circuit?
You may be referring to an air circuit breaker or, more accurately, and air-blast circuit breaker. This is a type of high-voltage circuit breaker in which the electrical arc, drawn when it opens, is stretched and snapped by a blast of air directed between the separating contacts -so the air is used as a method of extinguishing the arc. Often, these breaker's mechanisms are also driven by compressed air.
What is bleeding of turbine?
Bleed air in gas turbine engines is compressed air taken from within the engine, after the compressor stage(s) and before the fuel is injected in the burner
How does an oil burner work?
Oil burner magic!!
What is the air vents in a Bunsen burner?
The air vents in a Bunsen burner control the amount of air entering the burner. By adjusting the air vents, you can control the flame produced by the burner, allowing you to achieve different types of flames for specific experiments or applications.
What covers air hole in a burner?
The function that covers the air hole in a Bunsen burner is the collar.
What creates the air blast in a blast furnace?
Hot air under pressure
What does an air register do on a burner?
just it control the quantity of air supplied to burner .It is also called as damper.
What controls air flow in a Bunsen-burner?
The air flow in a Bunsen burner is controlled by adjusting the collar around the base of the burner. By opening or closing the collar, you can regulate the amount of air that mixes with the gas, affecting the flame's size and temperature.
What is the thing used to control the air flow in a Bunsen burner called?
The device used to control air flow in a Bunsen burner is called a "air hole" or an "air vent." It is typically located at the base of the burner and can be adjusted to regulate the amount of air entering the burner, affecting the flame's intensity and color.
What was the blast of air that flattened Nicodemus ear as hethe rats and the mice were escaping?
The blast air that flattened Nicodemus was air.
What does striking back of burner means?
The term "striking back of burner" refers to a situation where the flame on a gas burner goes out and then reignites. This can happen due to a disruption in the flow of gas or a change in air pressure around the burner. It is important to address the underlying issue to ensure safe and efficient operation of the burner.
What happens when you cut the air supply down on a Bunsen burner?
the burner stops burning
What causes a burner to stike back?
A burner can strike back due to an excessive flow of gas or air, causing the flame to ignite outside the burner. This can happen if the burner is not properly adjusted or if there is a blockage in the gas or air supply lines. Improper maintenance or a malfunctioning burner also increases the risk of a burner strike back.
What is the purpose of the restrictor in the blast tube?
A restrictor in the blast tube serves to regulate the flow and velocity of the air or gas passing through, controlling the intensity of the blast or flame. It helps ensure a consistent and controlled output for applications such as heating, welding, or metalworking.
What is the movable part of a Bunsen burner?
The movable part of a Bunsen burner is called the air hole or air vent. By adjusting the air hole, you can control the amount of oxygen mixing with the gas, which in turn affects the type of flame produced by the burner.
