It is a deformed round steel bar and has a diameter of 12mm.
The only difference between Y12 and T12 is the Kilos per meter. In a Y12 there is 0.888 Kilos and a T12 bar has 0.612 Kilos.
785okg/m3
In the context of concrete reinforcement steel, a Y12 bar refers to a deformed steel bar with a diameter of 12 millimeters. The "Y" indicates that it is a high-strength deformed steel bar. On the other hand, an R10 bar refers to a round steel bar with a diameter of 10 millimeters. The "R" signifies that it is a mild steel bar without any deformations.
KSI steel bar refers to a type of steel reinforcement bar (rebar) that is designated by its yield strength in kilopounds per square inch (KSI). Common grades include 40 KSI, 60 KSI, and 75 KSI, indicating the minimum yield strength. These bars are used in construction and civil engineering to reinforce concrete structures, providing tensile strength and improving durability. The higher the KSI rating, the stronger the bar, allowing for lighter designs and reduced material usage.
A short piece of solid bar steel used when jointing 2 pieces of tubing. The tubes are slid over the slug, to reinforce the joint and it adds additional metal to weld too.
The only difference between Y12 and T12 is the Kilos per meter. In a Y12 there is 0.888 Kilos and a T12 bar has 0.612 Kilos.
785okg/m3
To determine how many Y12 bars can replace a Y16 bar in a column, you need to consider the area of steel provided by each bar. The area of a Y16 bar is approximately 201 mm², while a Y12 bar has an area of about 113 mm². Therefore, to replace one Y16 bar, you would need about 201/113 ≈ 1.78, meaning you would need at least 2 Y12 bars to provide a similar cross-sectional area of steel.
170 Y12 Bar to the ton at 6000 M long
A Y12 bar typically has a cross-sectional area of 113 square millimeters.
12mm
In the context of concrete reinforcement steel, a Y12 bar refers to a deformed steel bar with a diameter of 12 millimeters. The "Y" indicates that it is a high-strength deformed steel bar. On the other hand, an R10 bar refers to a round steel bar with a diameter of 10 millimeters. The "R" signifies that it is a mild steel bar without any deformations.
0.887 kg per m
You can reinforce steel by either decreasing the span length or increasing the stiffness of the steel. Reinforcing steel improves safety and design effectiveness and decreases deflection.
There are 907,185.01 y12 in a ton.
5X = Y12 ???? If so...., Y12 = 5X Y = 12th root(5X) ===============
500W in steel bar means this steel yields 500MPa strength