answersLogoWhite

0

i think sag compensation springs are used in dead end termination of quadra conductor bus where jack bus is passing below bus & required clearence if we are not getting betn two buses their these sag compensation springs are used to bring conductor under tension .

User Avatar

Wiki User

14y ago

What else can I help you with?

Continue Learning about Engineering

Sag produced in the conductor of a transmission line depends on?

-The tension of the cable (the tighter, the less sag, but this can cause other problems if too tight) -The temperature outside (the higher the temperature, the more it will sag) -The amount of current flowing through the cable (the more current, the hotter the conductor will get = more sag) -The type of cable (aluminimum will sag more than copper; ACSR will sag less than straight aluminimum).


When Ontario Hydro workers set up electrical cables during the summer they allow the cables to sag. Suggest a reason for this. In your answer refer to the particle theory?

i know someones going to be on this sooooooooo....... they sag because the hydro workers know, from the heat the cbles will sag during the summer, so they start the sag so they cant sag anymore


How do sag's in power transmission formed?

The plural of sag is sags, not sag's! Sag is caused by the weight of the conductor between its supports, and is (a) unavoidable and (b) necessary to allow for the conductor's expansion and contraction during variations in temperature. When surveyors design a power line, the amount of necessary sag is calculated and built into the design, while ensuring that the clearance between the conductor and the ground remains within safe limits.


What is a sag of transmission line?

The sag of a transmission line refers to the vertical displacement or dip of the line between two support structures, such as towers or poles, due to the weight of the conductor and the tension applied to it. Sag is a crucial factor in transmission line design, as it ensures adequate clearance from the ground and surrounding structures, while also allowing for thermal expansion and contraction of the conductors. Proper sag calculations help prevent mechanical stress and potential failure of the line under various environmental conditions.


What is the difference btn sag and surge?

Sag refers to the downward displacement of a cable or structure due to its own weight, often observed in power lines or suspension bridges. Surge, on the other hand, typically refers to a sudden increase in electrical voltage or current, which can cause damage to electrical components. While sag relates to physical tension and weight distribution, surge pertains to rapid changes in electrical systems.

Related Questions

What causes the rear end to sag in a land cruiser troop carrier 84. shock absorbers or springs?

Probably springs. Standard shocks don't lift unless they are air shocks.


What is to hang or sink downward?

sag


What is a three letter word which means to hang or sink downward?

SAG


What is the past tense of sag?

The past tense of sag is sagged.


Why sag setting in Transmission line?

The sag setting is necessary because it is physically impossible to have a suspended line with no sag. The sag is specified because there has to be a minimum clearance value for the height above ground at the centre of the sag where the cable is at its minimum height.


What is green SAG laser?

Sag lasers measure distance.


When was Ivan Sag born?

Ivan Sag was born in 1949.


Is Sterling Talent Agency in Kent Washington an SAG member?

Not according to the SAG website. Yes they are according to the SAG Website....


Where is the Sag Harbor Whaling Museum in Sag Harbor New York located?

The address of the Sag Harbor Whaling Museum is: 200 Main St, Sag Harbor, NY 11963


How do you get a SAG membership card?

You can get a SAG membership card upon appearing in a film, and applying for the card. SAG cards can also be awarded to extras, and once dues are paid, the SAG card will be given.


Where is the Sag Harbor Historical Society in Sag Harbor New York located?

The address of the Sag Harbor Historical Society is: Po Box 1709, Sag Harbor, NY 11963-0062


Where is the Serve Sag Harbor Inc in Sag Harbor New York located?

The address of the Serve Sag Harbor Inc is: Po Box 775, Sag Harbor, NY 11963-0019