0
According to some other sites that were researching the speaker and cab for use as a home cab for a bass, the specs are (when new):
Impedance: 8 Ohms. - Power capacity: 800 W Peak, 400 W Program, 200 W Continuous. - Sensitivity: 94.9 dB / 1 W 1 m. - Usable freq. range: 60 Hz ~ 4 kHz.
Still curious? Ask our experts.
Chat with our AI personalities
ReneChange my mind. I dare you.
Chat with Rene
FranI've made my fair share of mistakes, and if I can help you avoid a few, I'd sure like to try.
Chat with Fran
BeauYou're doing better than you think!
Chat with BeauAdd your answer:
Earn +20 ptsQ: What is Peavey Model 112H 8 ohm Theatre Speaker Power handling capabilities?
Write your answer...
Submit
Still have questions?
Trending Questions
Even though the concrete slab repair method was a more permanent technique what problem did they cause?
What are the factors which effetcs ignition lag?
What is adaptive control machining system?
What base is most commonly used to unclog the drains?
What factor made industrial growth possible?
Is this normal during a parallel of two generators where lead generator is higher in both load ampere and reactive power than the lag generator but with the same frequency same kilowatt load?
How long will a 160 gallon tank take to become empty at 280 CFM with an opperating pressure of 100psi?
What is least used FM radio freq in US?
How can design reviews improve designs?
Equalizing lines should be located in multiple condenser and compressor applications where Between condenser and evaporator coils or Near the TXV or Between compressors and condensers or None of them?
How do you differentiate between positive displacement pump and roto dynamic pump?
What is actual path of execution of a program?
Are there any STL headers which are not part of the C plus plus Standard Library?
What is the Freezing point of fish oil?
What is therapeutic cloning?
What does it mean to use resources carefully?
Any possible binary logic function can be implemented using only?
How do you overcome disadvantages of fixed bias configuration?
When burning your wood stove some times you open to put more wood in and there is a layer of charcoal not fully burned. Is this from not enough incoming air.Pipe damper is closed too much?
When is the Op amp said to be working in its linear range?
Copyright ©2025 Infospace Holdings LLC, A System1 Company. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Answers.