There are three effects produced by an electric current:
The current measured at any point in a simple circuit will be the same because current is the measure of electron flow through a circuit. The current flowing through any branch of any circuit (or an entire simple circuit) will always be the same at any point.
No. Circuit is open but still HOT.
Circuit breakers do not use anything, they are a controlling device. They can automatically open the circuit if the current exceeds the current rating and you can manually disconnect the power from the circuit.
A battery, a light bulb and a switch
In a simple alternating current generator, electrical connections with the rotating coil are typically made using slip rings. These are conductive rings attached to the coil that rotate with it, allowing for a continuous electrical connection with stationary brushes that maintain contact with the slip rings. This setup enables the generated alternating current to be transferred to an external circuit while the coil rotates within a magnetic field.
increase
Ohms Law
Impedance in physics refers to the measure of opposition to the flow of alternating current in an electrical circuit. It includes both resistance and reactance. In simple terms, impedance determines how much a circuit resists the flow of current, affecting the overall behavior of the circuit.
A circuit needs at least three electrical contacs.
The current measured at any point in a simple circuit will be the same because current is the measure of electron flow through a circuit. The current flowing through any branch of any circuit (or an entire simple circuit) will always be the same at any point.
When you switch off an electrical circuit you tend to create a 'break' in the circuit, preventing the electric current to flow around the circuit, this can be caused by a simple switch or a break in the circuit, e.g a disconnected wire.
depends on the simple circuit. please describe it.
For an electrical circuit to keep going, it cannot be interrupted. When the switch is adjusted, the electrical flow is interrupted. Move the switch again and the flow is restored. Without a switch a circuit is no longer considered a complete circuit. Simple fifth grade science.
you need an electrical supply and a load. nice and simple.
Well, it is light-thermal energy. Simple as that.AnswerI think that you are looking for 'series circuit', but your question is rather vague.
Electricity from a simple generator is produced through the principle of electromagnetic induction. When a conductor, such as a wire coil, moves through a magnetic field, it generates an electric current. This current can then be harnessed to power electrical devices.
volts current ohms