answersLogoWhite

0

You should have about 230 volts between any pair of 3-phase service legs: L1-L2, L2-L3, L3-L1. If the voltage measured between any one pair results in low or no voltage, then you have a fuse or circuit problem.

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

What is total voltage in 3phase supply when one of the phase becomes zero?

There is no 'total voltage' in a three-phase system. There are three line voltages and three phase voltages.


Is 10 kva supply to 3 phase load is equal to 10kva supply to single phase load?

Yes of course!! 10 kva electrical power is 10 kva electrical power either it would be three phase or single phase. But other factors i.e. current, voltage changes accordingly. Actually this question is quit confusable. Because in 3phase system, if each phase gives 10kva power (single phase power = 10 kva) then 3 phase power will be 10 X 3 = 30 Kva If we go leteratualy towasrds the question, then the asnwer will be - No. becasue 10 kva supply to 3 phase load will be 3phase supply(i.e440V) & 10kva supply to single phase load will be single supply (i.e 250V).


How convert 1 phase to 3phase in aircraft?

The power is generated in the form of three-phase in aircraft, and this sytem has no problem in feeding single phase loads. To conserve mass in tansformers and motors the supply works at 400 Hz.


What comes inbetween melting point and boiling point?

liquid phase


Can a 220 volt 3 phase motor be connected to a 208 3phase curcit?

Yes.


What is the Max amp rating for 3phase dc motor?

the three phase dc motor never seen yet motor eaither 3phase m/r or dc motor.


Can i run single phase dc motor from 3phase bldc controller. i m using single phase motor in motorcycle and controller from other electric vehicle. if yes please tell me how to connect it?

It is possible to run a DC motor on a 3-phase supply using a full-wave rectifier if the voltage is right.


Can you get 180 degree single phase power from 3phase?

Rephrase your question so that it makes sense.


How many amps for 1hp 3phase?

For a 1hp 3-phase motor, the current draw will depend on the voltage supply. Typically, at 230V, a 1hp 3-phase motor will draw around 3.6 amps. However, this value may vary based on the motor efficiency and power factor.


What is name of motor having 3phase winding single phase winding with permanent magnet and a tachogenerator?

Its a servo.


Phase difference between voltage and current at resonance?

The power factor is a measure of the phase difference. If they are exactly in phase the PF = 1. If they are 180 degrees out of phase PF = 0.


How many microfarad of starting capacitor is best for 15hp 3phase motor?

Starting capacitors are only required for single-phase induction motors. They are not necessary for three-phase motors.