A single phase 10 HP motor will draw aproximately 50 amps. A three phase 10 HP motor will draw aproximately 28 amps.
Horsepower is horsepower, so a 16 hp electric motor could, on the surface, replace a 16 hp gas motor. Things to consider, however, include RPM and torque. Gas engines are inefficient, to replace a 16 hp gas engine it would take only a 8 hp electric. standard closest size would be a 10 hp. I have done this several times on air compressors and hydraulic pumps.
25 HP is 25 HP, no matter how you slice it and dice it.
The largest 120V motor generally available is 3hp. A 3hp, 120V motor draws about 30 amperes. All true 5hp motors I have seen are 230V or higher. Note that some motors, such as compressors and vacuum cleaners, use artificially high hp numbers to entice you to buy their unit (they will use terms like peak-developed hp, etc.). These ratings are not true hp, and you just have to go by the nameplate rating on the unit. For instance, I have a Sanborn Air Compressor that claims 4 PEAK horsepower, yet only draws 17 amperes at 120V. Its really closer to a 2hp motor.
acu compressor motor window type aircon 45 uf capacitor for 2.5 hp compressor 50 uf for 3 ton acu 60 uf for 1.5 hp compressor 35 uf
Yes, with no problems at all.
For persons under 200 pounds, 70 hp would be the smallest motor I would reccomend. For persons over 200 pounds, a minimum of 90 hp. Of course the more horsepower, the easier it is to get the skier up and the less it wears out your skier!
That depends on what you intend to use it for. It would probably work well for fishing or cruising on a small boat, but I think you would find yourself wanting more HP to pull a skier or tube.
i have a 50 hp force on a 18 foot invader boat a i pull one just fine only shows problem when u have three or more on tube so have fun
how do you adjust timing on a 50 hp 1985 Yamaha outboard motor
Yes, but it does depend on the skill of the skier and to some extent the design of the water skis.
50 hp Force 2-Stroke Outboard Motor. Force 50 hp Outboard is a long shaft. Force 50 hp only weighs 152lbs!! It is one of the lightest 50hp outboards ever made. This is advantageous as it will deliver 50 hp without weighing the transom down.
What is the weight of a 1966 45 hp mercury outboard motor
50:1
This question depends on the type of boat you have. Normally as long as your boat can do around 25+ mph you should be able to pull a skier out of the water. So if you have a 18ft boat with a 115hp depending on the weight of the boat you will be able to tow a skier out of the water.
How do I remove the lower unit from my 1984 50 hp. Mercury outboard motor?
Yes, but not very fast.