Connected with the water supply
The F17 error code on a Kenmore Elite washer indicates a water supply issue, specifically that the washer is not receiving water within the expected time frame. This can be caused by closed valves, clogged hoses, or issues with the water inlet valve. To resolve it, check that the water supply valves are fully open, inspect the hoses for kinks or blockages, and ensure that the inlet filters are clean. If the problem persists, the water inlet valve may need to be tested or replaced.
To decode the error message on your LG washer, refer to the user manual for a list of error codes and their meanings. Look up the specific code displayed on the washer to identify the issue and troubleshoot accordingly.
F25 error code is related to the Tachometer within the MCV Motor Control Unit. Motor speed isn't properly detected so the machine shuts down. Issue is determining whether the MCU is bad, sensor is bad, or something else affecting the speed of the spin cycle spin.
Long drain.
The error code E02 and F06 on a Maytag washer could mean that the hot water solenoid went out. It could also mean that that the hot water control is not working properly.
The UE error code on a Kenmore washer indicates an unbalanced load. To resolve this issue, try redistributing the clothes in the washer to ensure they are evenly distributed. You can also try reducing the load size or running a spin cycle to help balance the load.
Some common reasons for a Kenmore washer displaying the error code F21 include clogged drain hoses, issues with the drain pump, or problems with the water inlet valve.
Error code 90 on an AEG washer dryer means a loose connection between the main pcb to the display pcb. In total there are 5 blue wires which can be seen by removing the lid which could potentially be loose.
The F6 E2 error code on a Maytag washer typically indicates a communication issue between the control board and the motor control unit. To reset the error, you can unplug the washer for about five minutes, then plug it back in. If the error persists after the reset, it may require further troubleshooting or the assistance of a technician to address potential wiring or component issues.
The LE error code on the LG washing machines usually means:faulty hall sensorfaulty stator assemblybad connection to hall sensor and/or stator assembly
commuication error between ccu and mcu
It means the THERMISTOR is faulty and most likely needs to be replaced