error code on 401 80082700
Connected with the water supply
F25 error code is related to the Tachometer within the MCV Motor Control Unit. Motor speed isn't properly detected so the machine shuts down. Issue is determining whether the MCU is bad, sensor is bad, or something else affecting the speed of the spin cycle spin.
Long drain.
AD is for auto dry. It isn't an error code. It is just set on an auto dry mode. (normal, delicate, sport)
The error code E02 and F06 on a Maytag washer could mean that the hot water solenoid went out. It could also mean that that the hot water control is not working properly.
Error code 90 on an AEG washer dryer means a loose connection between the main pcb to the display pcb. In total there are 5 blue wires which can be seen by removing the lid which could potentially be loose.
It means the THERMISTOR is faulty and most likely needs to be replaced
commuication error between ccu and mcu
The F35 error code on a Whirlpool washer typically indicates a water-level pressure sensor issue. This can be caused by a clogged or faulty pressure switch, air dome, or water inlet valve. It is recommended to check these components and replace any that are faulty to resolve the error.
To reset a Frigidaire Affinity washer, unplug the unit for one minute and then plug it back in. Press and hold the "Start" and "Pause/Cancel" buttons simultaneously for 10 seconds to reset the washer. This should clear any error codes or malfunctions.
F35 is a failure of the analog pressure switch. You can get a new one from Repairclinic.com It's an expensive part. Remove the top lid by undoing the three fasteners on the back of the top lid. Pull the lid towards the back and lift up.The pressure switch is a brown module inside a black housing with a black rubber tube connected to it. It is locate on the top right panel towards the rear of the washer. Rotated it 90degrees to free it. Remove the connector and rubber tube to replace.