Oil is put into the gas of a 2-cycle engine as coolant, as it does not have a reservoir of it's own oil. The oil to gas ratio is the ratio of oil to put in a certain amount of gas. A common mix is 50:1, meaning 50 parts gas to 1 part oil. Note: Only ever put oil in the gas of a 2-cycle engine, which will usually have the gas cap labeled with an oil can, and will sometime be labeled with the mixture ratio. 4-cycle engines will not run on an oil/gas mixture and will simply foul the spark plug and cause extra carbon buildup on the combustion chamber sides.
Do you mean "mixed gas" as in oil/gas mixture? Then unless it calls for it then the answer is no. If you do and it is a normal 4 stroke engine then it will cause excessive smoking and will eventually foul the carburetor and combustion chamber up. Good luck.
The Nazis Put them gas chamber, beat them, and shot them
To get lots of different oils from the main crude oil you must put it into a fractional distilaltion chamber.
Put oil directly into the cylinder chamber. remove spark plug wire & spark plug. put oil in chamber & slowly turn the blade trying to free the engine piston.
Well Hitler and the Nazis didnt like Jews so they put them in the gas chamber , (told them they were having a shower )and made them get undressed. Then the Nazis released the gas and they all got killed.
The gas chamber was not an event.
If there is a fault and thus high current flow and thus the substantial heat generation results into boiling effect on oil and gas / bubble formation takes place with in the oil chamber that surge out of the chamber. This is sometimes referred to as surge in oil.
Drain the oil and gas out of the crankcase and put oil back it should be OK
no..they get beat
put some gas into it and some oil and pull the cord put some gas into it and some oil and pull the cord
unleaded