The door of the mobile home must be carefully measured against the standard door. The problem lies in the framing of the door. The mobile home framing might not be adequate for the standard door hanging. Check with your installer BEFORE you purchase the door. In my case, there is a speciality home center that sells speciality doors for installation in mobile homes. Look in your local directory for such home centers.
Yes it will fit.
Yes, it will. Almost all mobile home plumbing is standard.
It depends on the size of the paper and the size of the locker door. A standard letter-size piece of paper (8.5 x 11 inches) will likely fit on a standard size locker door, but larger papers may not fit.
That is the lowest standard size for a swinging door. Patio doors are a couple inches shorter. You can have a door made to fit a shorter opening. It is usually better to raise the header to fit the standard door.
a 14.5 mobile home tire only.
Yes, just try it
Target Home Office folders do fit in standard office desks quite nicely, but it helps to measure your desk first.
Yes, you can. That is the common fit.
The biggest difference you will find between mobile home water heaters and house water heaters is the the mobile home version is generally slimmer in order to fit in the smaller spaces in a mobile home. The installation is also different as the mobile home heater feeds from the bottom and vents from the bottom.
No they will not. Vehicles with 2 doors have longer doors than a 4 door vehicle to make up the difference in body panel length. A door from a 2 door standard cab s-10 will fit the front doors of a 4-door blazer but this is the only situation where a 2-door and a 4-door will interchange.
Door lining is purchased as a pack and must be assembled to fit the home. A door frame is already assembled and a wall is built around it.
A residential main entry is 3 ft - 0 inches wide and 6 ft 8 in tall. The rough opening for the door and frame to fit into is 3 inches larger on the width and 1-1/2 inch on the height which will allow for the door and jamb and also any necessary adjustment required to plumb and/or square the door unit.