0
Add your answer:
Earn +20 pts
Can a 1994 Chevy 350 intake will it fit 1974 Chevy 350?
No. Not without switching the cylinder heads. I think it was 89, Chevy came out with the 1st generation Vortec heads, which require a different intake.
What do you have to do to use the heads from a 1983 Chevy 350 on your 1987 Chevy 350?
nothing. but the intake will be diff.
Will a intake manifold for a 85 Chevy 350 bolt to 97 Chevy vortec heads?
No not even close.
Where are the intake and exhaust valves located on a 305 Chevy engine?
In the cylinder heads.
Can you put 1985 Chevy heads on a 1999 Chevy block?
Yes, however, they both take different intake manifolds, so you will have to transfer the intake, as well.
Will Chevy 5.0 heads and intake fit a 5.7 short block Chevy engine?
Depending on years that you are swapping around....yes. The 305 heads will raise the compression of the 350 considerably. However, the intake valves are a lot smaller than the 350.
Can you put your Chevy 350 1983 intake and heads on a 1989 t.b.i Chevy 350 block will it work?
Yes you can but you will need to modify the bolt holes in the intake manifold. The TBI intake 4 center bolts, 2 on each side will not line up with the heads. Must drill them out just a little.
Will Chevy 5.7 heads and intake fit a 5.0 short block Chevy engine?
The 5.7 heads will work if they have the smaller 184 intake valves . Or you will have to bore the block over to get the 194 ,200,or 202 intake valves to fit into the cylinder if not it will lock it up when the valve opens and hits the edge of the block
How do you replace Chevy 454 head gaskets?
Remove carburator then intake manifold then cylinder heads
Will a Chevy 350 intake fit a Chevy 400 motor?
It depends on whether or not the intake ports match on the cylinder heads. You can get that info from one of parts exchange guides you may find online.
What is different from 1991 Chevy 350 heads then 1980 heads besides the intake bolts is the oil ports the same?
Yes the oil ports are the same.
On your 350 Chevy how to stop coolant leak between heads and maifold the heads have rear water jackets the manifold does not?
replace the intake gasket set
