The lid seal is compromised. It'll have to be replaced.
how do you pop the trunk from the inside on a 1992 buick park ave
motor is out or you have a fuse blown
yes, it does in my 1991 buick park ave.
It is not located in the trunk it is Mounted on top and inside the fuel tank.
If you have an automatic release like I had on a 1994 Buick P.A. and it stopped working and would not close, I had to replace the latch assembly to make it a manual by getting a used one from the salvage yard. The trunk still closes today.
Have you tried the trunk lock button inside of the glove box? Greg
My manual says 20.3 cu ft.
If it's the one where a electric motor closes the trunk for you, you might have to get the new electronic switch by the latch on the car. That's what I had to do.
To install a trunk lock on a 1991 Buick Park Avenue, first, remove the trunk lining to access the lock assembly. Disconnect the electrical connector if the lock has a keyless entry feature, then unscrew the old lock from its mounting bracket. Install the new trunk lock by securing it in place with screws, reconnect the electrical connector if applicable, and replace the trunk lining. Finally, test the lock to ensure it operates smoothly.
check wire's in trunk right side i had one cut off it was a brown wire
Yes, the 1994 Buick Park Avenue does have a fuse related to the trunk release system. You can find this fuse in the fuse box, typically located under the dashboard or in the engine compartment. If the trunk release isn't functioning, checking this fuse is a good first step in troubleshooting the issue. Consult the owner's manual for the specific fuse location and rating.
Yeah they will just put rubber band tires on the rim and not alot sounds in the trunk ...