answersLogoWhite

0

1. The crankcase breather may be plugged. or----

2. Too much crankcase pressure. There is too much blowby (combustion gasses leaking by the rings or piston), causing excessive pressure in the crankcase. To repair this, you will need to re-ring or bore out the engine with new pistons and rings.

User Avatar

Wiki User

14y ago

What else can I help you with?

Related Questions

Is there a difference between reading a car dipstick as opposed to reading a dipstick on a lawn tractor?

no


What would cause the dipstick on dodge neon to blow out of the tube?

wah wah wah


How do you check the hydraulic fluid in a Kubota tractor?

Dipstick


Why would the dipstick on a lwb transit 1997 pushed out from pressure building up underneath?

Engine oil dipstick? Could be the PCV system is inoperative or the engine has excessive blow-by.


Where is hydraulic fluid dipstick in a 4610 ford tractor?

In a Ford 4610 tractor, the hydraulic fluid dipstick is typically located on the right side of the tractor, near the hydraulic reservoir. It is often mounted on the top of the reservoir or integrated into the fill cap. To check the hydraulic fluid level, remove the dipstick, wipe it clean, and reinsert it to get an accurate reading. Always ensure the tractor is on a level surface when checking the fluid level.


How do you fill hydraulic fluid into white tractor 1010 loader?

under the seat of tractor is the hydraulic reservoir. fill it to the line on the dipstick.


Where is the hydraulic dipstick on a SAME explorer tractor?

On a SAME Explorer tractor, the hydraulic dipstick is typically located near the rear of the tractor, often near the hydraulic reservoir. It can usually be found on the right side, close to the three-point hitch area. To check the hydraulic fluid level, you need to remove the dipstick, wipe it clean, and then reinsert it to get an accurate reading. Always consult the operator's manual for specific details related to your tractor model.


How do you check hydraulic fluid on long 2610 tractor?

Dipstick on transmission top-right


Where is the hydraulic filler on a 1066 international tractor?

directly below the parking brake their should be a dipstick going through the floor platform. between your feet when you are on the tractor.


Where is the Hydraulic fluid cap on a case 730 tractor?

The hydraulic reservoir on the case 730 should be in about the same area as the case 630......on the right side of the tractor at the rear of the engine and on what would be the bell housing is a large cap screw type plug. There should be a dipstick not too far from it....you add hydraulic oil there, if it is a case-o-matic. If it is a standard transmission, then the dipstick and the plug should be on the rear of the tractor around where the seat bolts on.


Where do you check the hydraulic fluid level in a Massey Ferguson tractor 240?

To check the hydraulic fluid level in a Massey Ferguson 240 tractor, locate the hydraulic reservoir, which is typically found near the rear of the tractor. Remove the dipstick or cap from the reservoir, and wipe it clean before reinserting it to check the fluid level. The fluid should be within the indicated range on the dipstick. Ensure the tractor is on a level surface for an accurate reading.


What would cause the filler cap dip stick to blow out on a 2003 Harley Sportster?

there is a check valve in the oil system that is stuck open over filling the oil tank will cause the dipstick to blow out of oiltank