Could be,
Low on brake fluid,
Parking brake not fully retracted,
Problem with the brake system,
Have a trusted mechanic inspect the brakes soon.
fix your brakes
The indicator light switch in a car's dashboard is used to signal to other drivers when the driver intends to change lanes or make a turn.
Release the handbrake
Just turn the key to on (second) position - where you see all the lights come on the dashboard and wait till the brake wear indicator light go off. If you replaced the tripped brake wear sensor, the light will go off in about 10-15 seconds...
Low brake fluid in master cylinder? Parking brake not fully released?
There is an electircal switch that 'senses' when the emergency brake lever is applied and lights a warning light on the dashboard to keep you from driving in this condition. This switch may be faulty or out of adjustment, causing the warning light on the dashboard to turn on.
Brake sensor indicator
no. however your indicator lights are located in your dashboard. dashboard light will light up when you turn your headlights on. Ex. the lights that are illuminated behind your miles per hour needle or behind your fuel gauge. Your indicator light are a lights that come on when your first turn the ignition. these lights indicate when your oil needs to be changed or your fuel is low or your washer fluid is low or the blue light that is illuminated when your headlights are on bright or high beam etc.....most newer model cars are equipped with the indicator lights. hope this is helpful.
How do you turn the brake indicator off on mini cooper s 2008?
To turn off the parking brake, locate the parking brake lever or button in your vehicle. If it's a lever, pull it slightly and then release it to disengage; if it's a button, simply press it to deactivate. Ensure that the vehicle is in the "Park" position if it's an automatic transmission, or in neutral for a manual, before releasing the brake. Always check that the parking brake indicator light turns off on your dashboard.
To turn off the brake wear indicator light on a 2002 Porsche Boxster, first ensure that the brake pads are replaced if they are worn out, as the light indicates that the pads need attention. After replacing the pads, the light may turn off automatically. If it doesn't, you can reset the indicator by disconnecting the battery for a few minutes or using a diagnostic tool to clear the fault code. Always consult your owner's manual or a professional mechanic for specific instructions related to your vehicle.
If it's the "change oil" light, turn the ignition to on, but don't start it, and tap the gas pedal 3 times.