A big red alien comes down from the sky and zaps your washer and then it spin drys!
my washer keep on by passing the spin cycle and will not drain out the water.
check the lid switch it is under the top of the washer and is usually activated by a pin attached to the lid of the washer
A blocked drain.
If your Whirlpool washer is not agitating or spinning, there may be an issue with the drive belt, motor, or control board. Check these components for any signs of damage or wear, and consider consulting a professional technician for further diagnosis and repair.
There are several things that could be causing a washer not to drain. The first and most simple explanation would be a clog in the hose. Another reason could be the latch to the lid is not closing tightly and therefore not allowing the washer to spin and drain. It could also be a broken belt or pump.
If your washer won't spin, it could be due to a broken drive belt, a faulty motor, a clogged drain pump, or a malfunctioning lid switch. Check these components to troubleshoot the issue and determine the necessary repair.
anticlockwise
There could be several reasons why a washer may not spin clothes dry. Some potential causes include a broken drive belt, a malfunctioning motor, a clogged drain pump, or issues with the door latch or lid switch. It's best to consult a professional technician to diagnose and address the specific problem with the washer.
Dead or alive - You spin me round. You spin me right round baby right round like a record (or whirlpool) baby right round, round round.
A clunking noise in a Whirlpool washer can be caused by a variety of issues such as a broken drive belt, worn drum bearings, or a loose drum pulley. If the washer is not spinning all the way out, it could be due to an unbalanced load, a malfunctioning motor, or a faulty control board. It is recommended to have a professional technician diagnose and repair the specific issue.
There could be several reasons why a washer is not spinning dry well. It could be due to an unbalanced load, a malfunctioning drive belt or motor, a clogged drain filter, or an issue with the lid switch. It's best to troubleshoot the specific problem with your washer or consult a professional for an accurate diagnosis.