answersLogoWhite

0


Best Answer

sounds like intake gasket did mine last year be sure to use little lock tight and torque to older 70s spec had no problems yet

User Avatar

Wiki User

16y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Why is water pouring out of intake connection on my 1998 GMC?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

My 1998 Chevy Malibu v6is now leeking coolant. First time this happened it was the water pump then it was the intake manifold. But now all the coolant came pouring out some one tell me what you tink?

There are several possible causes, only a pressure test of the system will tell. The GM V6 had some issues with intake manifold sealing, and there have been at least 3 different gasket designs that I am aware of.


Just fixed the intake on my 1998 S10 4.3 and now the temp gauge isn't working Any help?

Perhaps you didn't plug the connection back in. It would be the single wire connection that runs over the valve cover on the drivers side.


Radiator coolant leaking from beind radiator pouring out more on passanger side near front tire car overheating what can cause this on a 1998 dodge caravan?

Your water pump is bad


Where is the starter on 1998 Cadillac DeVille?

The 1998 most likely has a Northstar engine. On this engine the starter is under the intake, and the intake has to come off for replacement.


What does code po113 mean in a 1998 Chevy s-10 with a 2.2 lieter motor?

Intake Air Temperature (IAT) sensor 1 circuit high input. Check the connection at the IAT sensor.


What is the intake manifold torque specs for the 1998 Ford F-150 xlt?

What are the intake manifold torque specs for a 1998 ford f-150 xlt


Where is the mass air flow sensor on a 1998 mercury villager?

In a 1998 Mercury Villager, the mass air flow sensor is located in the air intake tube. The air intake tube goes from the air box to the intake.


What would cause the water temp gauge to jump around on a 1998 Chevy Malibu?

Probably either the sending unit or a loose connection.


How do you change the intake manifold gasket on a 1998 park avenue?

What engine? and ensure it is a bad gasket, not an intake plentum.


Where is the oil pressure switch located on the engine on a 1998 corvette?

IT IS LOCATED IN THE REAR OF THE INTAKE... YOU HAVE TO REMOVE THE INTAKE TO CHANGE IT....


How do you tell difference between exhaust valve and intake valve on 1998 suburban 5.7?

The intake valve is bigger.


Where is the intake manifold on the 1998 stratus?

it would be on the top of the moter