could be two things bad earth behind the dash or on the lights. Or if you control your lights on a stem coming off the steering column that could be faulty? it is indicating your daytime driving lights are on
possibley blown high beam light
Are you talking about the High Beam headlight indicator? That light is telling you your high beam lights are on. try turning off your high beam lights and see if the light goes away. If is stays on but the lights are not on high beam then its just an electrical issue, either pull the bulb out or cover the light with electrical tape if it bothers you!
no. however your indicator lights are located in your dashboard. dashboard light will light up when you turn your headlights on. Ex. the lights that are illuminated behind your miles per hour needle or behind your fuel gauge. Your indicator light are a lights that come on when your first turn the ignition. these lights indicate when your oil needs to be changed or your fuel is low or your washer fluid is low or the blue light that is illuminated when your headlights are on bright or high beam etc.....most newer model cars are equipped with the indicator lights. hope this is helpful.
The types of construction lights that are available are high voltage beam light and a low voltage beam light. The high voltage beam light shines a lot brighter.
Low beam head lights? High beam head lights? Day time driving lights? Tail lights? Brake lights? Dash lights? Signal lights? Dome light? Glove compartment light? Trunk light? License plate light? Courtesy lights? Give us a clue.
bad ground in high beam switch
Probably needs a new DRL module
Check fuses Check bulbs
On my 1990 Mazda 121, the low beam (and sometimes high beam) lights fail due to a faulty light switch on the steering wheel console. I have to pull it apart and clean up the contacts about once every year when it does it. The tail lights also go out. I can tell it has failed again as the dashboard lighting goes out. Andrew.
High-beam lights are your sencondary head lights in any veicle. They can usually be turned on with the same botton you use to turn your head lights on. High beam lights are use to see farther and wider in dark areas.
Fog Lights, but they usually use 2 versions of fog lights. A "pencil beam" and "driving Light". That is why they usually have 4 extra lights 2 of each. The Pencil beam is a direct narrow beam used to see farther down the road and a driving light is a wide beam to see the sides of the road directly in front of you. A commonly used rally fog light is made by HELLA
The signs indicate the status of the airbag, lights, and cruise control. By using the computerized dashboard, you will know if the air bag is on or off. You will know if you are using your high beam or low beam lights.