The high beam indicator light will be located on the right side of the instrument panel. It is in the same housing as the check engine, choke, brake, and seat belt indicator lights. The high beam indicator is the only blue one, making it easier to find.
Either a faulty engine temperature sensor or the wiring to it.
P0118 means: Engine Coolant Temperature Circuit HighP0118 means: Engine Coolant Temperature Circuit High
In order for a high temperature boiler or steam engine to produce superheated water, or steam?
Diagnostic error code number 118 with high temperature input on a Audi A4 means that the engine coolant is not running at the right temperature. When the engine is cold, it should be warm, and when the engine is warm, the temperature should be cooler in the engine. The problem could be with the Engine Coolant Temperature sensor or the vehicle could be low on fluid.
That sounds like problem in the cluster. The high beam indicator is cross wired to the check engine light when it shouldn't be.
Any hot object from which energy is extracted to do work. Within the cylinder of a gasoline engine is a high-temperature reservoir.
i just put in a new radiator and now temperature gauge reads high but their are no leaks
The ambient temperature in this case refers to the temperature outside the engine. This is relevant for calculations related to heat engine. The ambient temperature will of course vary, but it is usually somewhere around 300 K.
the high beam indicator is only on when the high beams are on
If the engine temperature gets too hot and the engine fail - safe cooling mode is activated the engine will eventually shut off
To find the engine room temperature, you can use a thermometer or a temperature sensor specifically designed for measuring high temperatures. Place the thermometer or sensor in the engine room for a few minutes to ensure an accurate reading. Make sure the equipment is capable of withstanding the high temperatures typically found in engine rooms.