The larger the wheels have a higher center of mass than a smaller one. The higher the center of mass, the smaller the tilt needed to cause the wheel's center of mass to move outside its base and cause the wheel to roll over.
assuming we are talking about a rear wheel drive vehicle, the smaller wheels weigh less and provide the least resistance.
Yes, although you will have to use a smaller diameter tire or your speedometer will be off.
If the outside diameter of the new wheel (tire) is smaller then the tire will have to make more revolutions to equal what the manufacturer calibrated the spedometer to. The result would be your vehicle reading higher than actual speed. The solution it to make sure the vehicle is recalibrated to the new diameter. Sometimes this is as simple as a gear change in the transmission (external)
The diameter of 700cc wheels is approximately 27.5 inches.
Yes, you can replace 18-inch wheels with 17-inch wheels, but you need to ensure that the new wheels are compatible with your vehicle's specifications, including bolt pattern, offset, and brake clearance. Additionally, switching to a smaller wheel may affect handling, ride quality, and speedometer accuracy due to changes in tire diameter. It's also important to choose the appropriate tire size to maintain overall performance and safety. Always consult your vehicle's manual or a professional before making such changes.
there is most likely a censer on one of the wheels of the vehicle
Yes as the wheels will hit the calipers and will not operate properly if you could even get them mounted.
The main difference between 27" and 700c wheels for bicycles is their diameter. 27" wheels have a diameter of 27 inches, while 700c wheels have a slightly smaller diameter of about 27.5 inches. This difference in size can affect the overall ride feel and handling of the bike, as well as the compatibility with different tire sizes. Riders may notice differences in speed, stability, and comfort between the two wheel sizes.
The larger wheels roll much easier over rough terrain. Smaller wheels can get swallowed by small divots and bumps where a larger diameter wheel will roll over the smaller divot's without dropping down in.
125.7 feet = 1508.4 inches Circumference = 1508.4/16 = 94.275 inches Diameter = 94.275/pi = 30.00866452 or 30 inches to the nearest inch
The Boeing 747 has a total of 16 wheels: four main landing gear wheels on each side and two nose landing gear wheels at the front. The main landing gear wheels typically have a diameter of about 25 inches (63.5 cm), while the nose gear wheels are slightly smaller, with a diameter of approximately 20 inches (50.8 cm). These large wheels are designed to support the aircraft's weight during takeoff, landing, and ground operations.
Well, that depends on the specific type of bus. Smaller buses may have four wheels. Six wheels is pretty common for buses. Some may have eight or ten wheels, depending on the vehicle's gross weight rating.