answersLogoWhite

0


Best Answer

Its probably the throttle position switch.

User Avatar

Wiki User

12y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Why does Loose accelerator cable do high revs on Mazda Demio?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

02 Mazda pro 5 e brake cable loose?

HOW DO I TIGHTEN EMERGENCY BRAKE CABLE ON A 2002 MAZDA PROTEGE 5?


The lever used to fold down rear seats in your Mazda Demio has become unattached How do you reattach the lever?

If the lever to fold down the rear seats in a Mazda Demio has become detached from the cable, it is possible to fix this by opening up the area of the seat where the lever should be. There should be a small plastic plate in the area protecting the lever from moving too far up or down. This plastic piece is either screwed in or is held in by clips. Remove the screws or clips and reach in to find the cable. Pull the cable up, insert the lever into the opening and connect it to the cable. Then close the seat back up.


How do you change a accelerator cable on a 95 lumina van?

The accelerator cable is connected with a swivel nut on each end of the cable. Loosen the swivel nut, by turning it to the left. The accelerator cable will come off. Reverse the process to install the new accelerator cable.


How do you change accelerator cable on 1985 corvette?

The 1985 Chevrolet Corvette accelerator cable is held in place with a swivel nut on each end of the cable. Turn the swivel nuts to the left to remove the cable. Reverse the process to install the new accelerator cable.


How do you install an accelerator cable on a 1983 Chevy Silverado C-10?

Your 1983 Chevy Silverado accelerator cable is held in place with swivel nuts on each end of the cable. Connect the accelerator cable and secure it by turning the swivel nuts to the right.


1973 Beetle accelerator cable?

how do replace an accellerator cable on a 1973 bug


How do you adjust the Accelerator cable for 1993 dodge caravan?

The cable does not have any adjustment.


How do it replace the accelerator cable for 1997 GMC Safari?

no


Is a broken or disconnected accelerator cable a likely cause of accelerator suddenly not working but engine is running fine?

Yes, a broken or disconnected accelerator cable is the likely cause for the accelerator pedal to quit working. The car will still run fine but will not be able to accelerate past idle.


What cable goes from the gas pedal to the engine on a 1997 Chrysler Sebring?

It is the accelerator cable.


Can a Nissan maxima accelerator cable fit into a c33 laurel?

Yes. Most accelerator cable can fit as long as the lengths the same. You may need to adjust it by clipping the end


How do you replace accelerator cable on 1979 scout2?

With determination and know how!