Wing mirror.
The fuse for the side view mirror on a Chrysler 300m is located under the driver's side dash, near the floor. It adjust the mirrors when driving in forward or reverse.
yes
Use a good epoxy .
No, that is not allowed in the US
a spotlight
unbolt the mirror from the car and look inside the mirror for a bolt to tighten, don't remember if it can be tightened or not.
its the square mirrors that are on the sides of your car front doors.
If your car is on and your driver side mirror motor is working then it can be anything from a break in a wire to a stripped gear in the mechanism to the mirror motor going bad.
Yes, there is a glue that can be used to re-glue a side car mirror. It is not an actual glue but more of an adhesive. That adhesive is construction silicone adhesive that is free of latex.
Many old bugs have aftermarket mirrors. On the bottom of the mirror, near the body of the car, there should be a hex nut. Sometimes its under the plastic. (just gently lift the plastic/rubber and you should be able to determine where the nut is by the replacent mirror you have.
The nuts holding the mirror to car are accessed by opening door and removing and door panels and/or trim that obstructs the nuts fastening the mirror to car.