It depends on the quality of clutch in the vehicle you have. my sister used to ride her clutch a lot, as did a few other people i knew. If you are lucky, your clutch may last a year or two... its best not to ride the clutch too much if you can help it.
yesyes
actually i ride bikes and the clutch to change gears is on the left , very few have it on the right
instead of using the clucth to activate the gear, the clutch is used the majority of the time to either 'coast' or alterate the speed of the car.
It depends on what quad you are riding. If you are riding a honda(2005 and under) you must first hold the clutch and then kick start it. After that first gear is down and the rest are up. Remember you must hold the clutch when switching gears. Same goes for other quads except the part where you kick start it but you must still hold the clutch kick start
It's advisable to clean and lube your clutch after every ride or two - depending on the conditions. If you drive a lot of trails/sand/dusty conditions, its best to do it every ride, but if you're mostly on the street every 3-5 times would be fine. Your clutch could be worn out, but you can try to clean and lube it and see if that takes care of it. Otherwise, max-torque and comet clutches are widely available for it. With the engine off, and cooled down: Remove the Clutch Cover Blow out the clutch with compressed air (from an air compressor) Oil the clutch BEARING with a few drops of oil. MAKE SURE OIL DOES NOT GET IN THE CLUTCH Roll the mini bike around to get oil throughout the bearing surface. Install Clutch cover. Try to ride! If that doesn't work, just get a new clutch - should be about $25-30 shipped.
verb - as in "ride the bike" noun - as in "go for a ride"
It all depends on your driving style and how often the clutch is used. If you do a lot of city driving, the clutch will last far fewer miles than if you drive hundreds of miles without stopping. If you "ride the clutch" when you drive, the clutch might not even make 20,000 miles.
There are 2 ways, you can start a motorcycle. The best is to have the gear in neutral either after your last ride or before you press the starter button. Then all you have to do is turn the key, make sure the fuel tap is on and press the starter button to start the engine. Or if your motorcycle is in first gear already, squeeze the clutch handle in, to disengage the clutch and press the starter button. Only start to release the clutch, as you start to ride.
you put the gear in reverse and slowly let up the clutch until the car starts moving. then just ride the clutch so you don't kill the engine.
Why don't you take it to a mechanic before you ruin your truck by riding the clutch? The chattering could be engine knock because your engine is out of tune. When you ride the clutch, the clutch slips and puts less strain on your engine as you are burning out your clutch.
sit down jam it in gear give it gas dump the clutch and htfo