answersLogoWhite

0


Best Answer

The right hand would be used to turn the wheel

User Avatar

Anonymous

Lvl 1
4y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Which hand wheel would a machinist use to manually turn down a workpiece parallel to the ways?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Is the 2004 Acura MDX all wheel drive?

Yes but its tuned on manually


Installing rear wheel bearing on 94-97 Lexus GS300?

Wheel bearings on a 1994 to 1997 Lexus GS300 are pressed into the Hub. The install a wheel take the hub to a machinist so they can safely press the wheel bearing into place. This reinstall the hub onto the vehicle.


Lift the spoiler manually on a 2000 911 cabriolet?

there is a switch by driver interior panel underneath the steering wheel. up raises the spoiler, down lowers it manually.


Hard grinding wheel is prefered for soft and soft grinding wheel is prefered for hard work piece why?

It depends on the forces that would be applied on to the workpiece, a soft grinding wheel has more wear, and hence would not be affected much by hard materials. If we tried to use a hard grinding wheel, there would be large forces and hence a large wear on the wheel.


When manually bleeding the brake system on a diagonally-split front-wheel-drive vehicle the technician bleeds the Right Rear wheel first Which wheel should he bleed next?

Left front.


What are the advantages of power steering over of manual?

power steering is easier and you do not have to turn the wheel as hard as manually.


Why are wheelchair wheels not parallel?

The wheels aren't parallel because when the user is turning a corner the wheel that is on the outside of the wheel chair not the the one you are turning on (the offside) leads the rest of the chair round to where it is being directed


What does a balance wheel do on a sewing machines?

raise the needle feed or remove mistakes neellushah


How do you replace rear wheel bearing assembly Chevy impala?

A wheel bearing is pressed in to the hub so that it is able to safely operate. To replace a bearing on a Chevy Impala remove the hub from the car and take the unit to a machinist. Have the press out the old bearing and press in the new one.


How could you improve on a sharpener?

Abrasive wheels are commonly used to improve the sharpness of cutting tools. The finer the abrasive wheel, the smoother the finish on the workpiece. However, this will be at the expense of heating up the workpiece. So for soft materials, and rapid removal of material, use a coarse grinding wheel. For hard materials and to obtain a fine finish on the material use a fine grinding stone. For the finest work, diamond or Boron nitride are often used. Coolants are often used, and these may actually ease the grinding action.


How do I manually lift the front jacks on flagstaff fifth wheel RV when battery is dead?

Jumper cables and a friendly neighbor in camp.


How do you manually align 94 Toyota Corolla?

If you mean the wheel alignment, you have almost no chance to do it manually without special tools. In car services they use lasers to align wheels. If you have such precision in your hands then you can to that, if you don't. You have to bring the car to your mechanic.