0
Add your answer:
Earn +20 pts
How do you hook up tachometer to a Chevy 350 that does not have HEI distributor?
Connect the green wire to the negative side of the coil.
Where is the Knock sensor on a 1993 Chevy Cavalier?
Its located up and alittle to the right of coil packs on back side of block
Where is the coil pack on 2000 chevy s10?
If it is the 2.2 engine, on the lower passenger side of the engine block. It is best reached from underneath.
Witch coil wire controls the tach?
are you talking about a sm. block hei. dist. if so there are 2 spade connectors on the side of the cap , one says tach. The tach signal comes from the negative side of the coil.
How do you hookup a tach on a 292 Chevy?
negative side of coil, or if electronic distributor it will have a port on the distributor, then its power wire and ground and then same for lights
Where is the ignition coil located on a 1997 Chevy Cavalier 2.4L and how do you change it?
Firewall side of the engine block, couple of bolts hold it to the block, pull straight away from the block when removing as crank sensor, (extending approx. 2-3" long into the block), is mounted directly behind it to the coil/module base
Where is the negative side of a coil on a 93 Toyota t100?
The negative side of this coil is that it doesn't have a injector pulse. There also was a problem with the lack of spark.
Where is the coil and coil wire on a 1999 Chevy s 10 2.2l 4-cylinder?
There is no coil wire only spark plug wires. The coil pack can be found on the lower passenger side of engine block. It is best seen and accessed from under the vehicle.
How do you hook a Pro comp distributor to motor With a exturnal coil?
red (+) wire to possitive side of coil- Black (-) wire to negative side of coil. thats it.
Where is the ignition coil on a 2001 Chevy S-10 2.2 l?
The ignition module and coils are located on the lower passenger side of engine block. It is best to access from underneath.
Where does the negative battery cable bolt to the block on a 91 Chevy silverado?
Pretty much anywhere on the engine block, but factory location is right front corner of the block. That is the passenger side of the vehicle. Right and Left are determined by driver setting in vehicle. Left side is drivers side, Rt side is passenger side no matter what direction you are looking at.
Where is the knock sensor for a 1999 Chevy S10 2.2L 4 Cylinder SFI located?
Passenger side of engine block, close to the coil pack, probably easier to reach from underneath.
