Wiki User
∙ 11y agoThe bench seat back on a 1989 GMC uses an inertial locking system which automatically locks the seat back upon sudden deceleration. The latches are located on the pivot assembly on each end of the full seat back. I found that my seat back would not unlatch because a piece of rope had been pinched between the latch and the latch frame.
To unlock the seat, I removed the pivot bolt by exposing it from the outboard seat upholstery (simply lift the upholstery to locate the pivot bolt and remove the bolt with a 5/8 inch socket wrench. Once the pivot bolt was removed, the seat back could be pulled forward and the offending rope was removed. Replacing the pivot bolt restored the seat back to normal operation.
Wiki User
∙ 11y agoPlace the supplied wheel chocks back to back and sit the jack on top of the chocks. Raise the jack to the center of the spare tire and depress the release button. This will unlock the latch and you can lower the tire with the winch.
back drivers side next to fold out bench bed-brown grill cover
if you're referring to the tailgate latch, you 'll likely need to replace it. it isn't hard, i did this on my 1987 S15 jimmy, i just found it to be a pain moving the window latch aside without removing it completely
On a regular cab, it is against the back cab wall behind the bench seat on the driver's side. In an Xtra-cab, it is in a small compartment under the passenger side jump seat
Back Bench Student - 2013 is rated/received certificates of: India:U/A
How to finish the back of a latch hook rug. I have a rectangular rug and a round one.
Usually if you loosen the screws on the latch receiver mounted on the cab edge, the latch can be shifted up/down or front/back.
The back hatch will often not open if the internal mechanism or release has become damaged. Replacing the latch is the most effective and reliable fix.
When you have a bench in front of you, a bench step up is when you step up onto the bench, take that foot off to replace with another foot, then back down.
yes
The bench part, with a comfortable, heavy-duty back pad, is 68 inches in length.
Since there are different seats available for these vans, would need more information. If you have the center bench like I do, then you can't make any adjustments at all. The back bench usually has a lever at the front of the seat on the passenger side that allows you to slide it forward and backward. It may or may not fold. If it does fold, the latch is usually on the side, or on the back of the seat. Basically, if you can't find a lever somewheres, then you can't adjust it.