Follow the wire that comes out of the distributor (obviously not the wires that go to the plugs)
I have 1994 GMC 1500 with 305 mother if you cut the wire that comes from your ignition to the coil can it stop you from having fire to your
with a mechanic
Need to replace ignition coil "D" for my 2000 GMC Sierra 5.3. Need to know which coil is coil D. Thank you, Adam
The timing for this engine is electronically controlled and not adjustable
To replace the ignition coil on a 2002 GMC Sonoma, first, disconnect the negative battery terminal to ensure safety. Remove the engine cover if necessary, then locate the ignition coil, typically mounted on the engine. Disconnect the electrical connector and remove the bolts securing the coil in place. Install the new ignition coil by reversing the removal steps, ensuring all connections are secure before reconnecting the battery.
To replace the ignition coil on a 1994 GMC Sonoma pickup, first, disconnect the negative battery cable to ensure safety. Remove the ignition coil cover if applicable, then disconnect the electrical connector and unscrew the mounting bolts securing the ignition coil. Carefully lift out the old coil and install the new one, securing it with the bolts and reconnecting the electrical connector. Finally, reconnect the battery cable and start the engine to test the new coil.
To change the ignition coil on a 2000 GMC Safari, first, disconnect the negative battery terminal to ensure safety. Remove the engine cover if necessary, then locate the ignition coil, which is typically mounted on the engine. Disconnect the electrical connector and the mounting bolts, then carefully remove the old coil. Install the new coil by reversing the removal process, reconnect the electrical connector, and reattach the battery terminal.
at coil passanger side of engine
It is most likely the pick-up coil "inside the distributor".It could also be the coil or the ignition module.
should b at coil if not its under distributor cap
On a 2001 GMC Sonoma, the ignition coil is typically located on the engine block, near the cylinder head. It's usually mounted on or near the intake manifold, often on the driver's side of the engine. In some models, it may be integrated into the ignition control module. For precise location, it's best to consult the vehicle's service manual.
You might try a crankshaft position sensor first. Its probably cheaper than an ignition module.