A 1998 Dakota does not have a ballast resistor.
On a 1989 Dodge Dakota, the ballast resistor is typically located on the firewall, near the engine compartment, close to the distributor. It is a small, rectangular component often mounted on a bracket. If you're having trouble locating it, follow the wiring from the ignition coil, as the ballast resistor is part of that circuit.
The ballast resistor in a 1994 Dodge Dakota is typically located on the driver's side of the engine compartment, mounted on the inner fender or firewall. It is a small, rectangular component with electrical terminals connected to the ignition system. If you're having trouble locating it, consult the vehicle's service manual for a detailed diagram and specific instructions.
A 1994 Dodge Ram does not have a ballast resistor.
It does not have a ballast resistor, those were used for ignition systems 30+ years ago. It does have a blower motor resistor that is located behind the glove box.It does not have a ballast resistor, those were used for ignition systems 30+ years ago. It does have a blower motor resistor that is located behind the glove box.
On a 1979 Dodge 318 RV, the ballast resistor is typically located near the ignition coil, mounted to the firewall or on the engine compartment's inner fender. It is a small, rectangular component with two terminals and is often connected by wiring to the ignition system. If you're having trouble finding it, follow the wires from the ignition coil, as they usually lead directly to the ballast resistor.
The ballast resistor is located on the left inner fender.
ballast resistor should be on the firewall under the hood. just follow the wires from the coil and you will find it
IT doesn't have a ballast resistor.
In a 1997 Dodge Stratus, the ballast resistor is typically located near the ignition coil, mounted on or near the firewall in the engine compartment. It can usually be found along the wiring harness that connects to the ignition system. If you have difficulty locating it, consulting the vehicle's service manual can provide detailed guidance.
No.
Usually against the firewall in the center It most liley does not have a ballast resistor.
On the firewall pass side.