where is the camshaft sensor on a 2006 Dodge ram 5.7 litre
Wiki User
∙ 2015-10-28 14:20:59The low pressure sensor on a 2006 Hummer H2 is located on the top rear of the engine. It is behind the intake manifold.
Disrupt the frequency of the signal from the speed sensor to the ECM.
P/S exhaust, after the manifold but before the catalytic converter, at the back of the motor, behind the valve cover.
Drivers side exhaust pipe before the catalytic converter.
The Intake Air Temperature (IAT) is usually located in the intake air duct or the air cleaner. It is a two wire sensor and acts as a thermistor. Use the owner's manual in case you need help.
Where is a camshaft position senser located on a 2006 Dodge durango/
Where is a camshaft position senser located on a 2006 dodge durango/
The 2006 Dodge Durango camshaft position sensor is located on the back end of the head. The position sensor should be labeled as such.
It is under the front outside of the passenger side cylinder head.
Depends on the engine. Should be on the flywheel.
2006 was the last Neon. The cam sensor was located on the driver side end of the cylinder head.
The 2006 Honda Accord camshaft position sensor can be found on the back of the right-hand cylinder head. The camshaft position sensor should be labeled as such.
Do you have a video of the hhr camshaft position sensor
It is the three wire sensor on the driver side end of the cylinder head.
The camshaft sensor for a 2006 HHR 2.4 is mounted on the passenger side of the block. It is close to the front, and bolts on.
do you need to take off the timing belt to replace a camshaft position sensor on a 2006 kia sorento
No. The camshaft position sensor and crankshaft position sensor tone wheels are different. It may fit, but the engine will not run.