where do u put hydraulic fluid in a Massey Ferguson 275
To change the hydraulic fluid in a Massey Ferguson 471 tractor, you will first need to locate the hydraulic fluid reservoir. Next, drain the old fluid by opening the drain plug and allowing it to empty completely. Once drained, replace the drain plug and refill the reservoir with the recommended type and amount of hydraulic fluid for your specific tractor model. Be sure to check for any leaks and test the hydraulic system to ensure proper functioning.
Right side of engine right past the cab if it has one.
finger it
To check the hydraulic fluid level in a Massey Ferguson 245, you will first need to locate the hydraulic reservoir, which is typically located near the back of the tractor. Next, ensure the tractor is on a level surface and the engine is off. Remove the dipstick or sight glass from the reservoir and wipe it clean. Reinsert the dipstick or check the sight glass to see if the fluid level is within the recommended range. If the fluid level is low, add the appropriate type of hydraulic fluid until it reaches the correct level.
from back of tractor right side below cab in front of rear axle a small dip stick is located.
On the left side of the gear shifters
Hydraulic oil sight gauge and filler cap are located on back side of tractor below the big red warning triangle. Sight gauge is a small round window. Do not run without hydraulic fluid, it services the transmission too !!
Standing behind the tractor look below the seat and just below the bodywork and there is a small (1") removable cap with a tube leading downward.
The same place as a massey165
thru the dipstick and vent hole by your bucket levers
There is a spout on the rear close to under the seat. See picture