gear box are using to change the various speeds in vehicles
Gear ratio is the ratio of the rotational speeds of the first and last gears. It reflects the change in mechanical advantage which results from the gears.
1st gear is for the slowest speeds , up to 15 mph or very steep hills 2nd gear is for speeds up to about 30 mph or hills, third gear is from 30-50mph, 4th and higher is for speeds over 55mph.
Not sure what you are referring to. On some transmissions it is the highest gear on others (8 and 9 speeds) it is a low gear.Not sure what you are referring to. On some transmissions it is the highest gear on others (8 and 9 speeds) it is a low gear.
there are a few reasons for engines knocking......... - bad type of fuel - higher gear ratio at slower speeds if your engine knocks when you start it up then you have probably got a bad or dirty fuel in your car... change the filters or just get away with using it and change your petrol station if the engine knocking happens during driving then its because you are putting more gas on at lower speeds and higher gear ratios...you just need to lower your gear. say change from gear 3 to gear 2 and try increasing the gas gradually and slowly and the knocking should go away....
I can find no recommended oil for this application. If it were mine I would run AMSOIL Severe Gear® Synthetic Extreme Pressure (EP) Gear Lube 75W-90
Yes, 90 weight oil is recommended.
It is recommended to change gear oil every 30,000 to 50,000 miles, or as specified in the owner's manual. It's important to follow the manufacturer's recommendations for your specific vehicle for optimal performance and longevity of the transmission.
Google can't find an Edlund bicycle.
on a 2000 intrigue; car does not shift into 3rd gear or 4th gear. 1st 2nd gear ok
The recommended type of gear lube is a GL4 in a viscosity of 75W90.
To provide varying speeds for the drive