answersLogoWhite

0

What else can I help you with?

Related Questions

Is TIG Welder is also considered as Co2 welder?

No , although Co2 may be used , along with other gasses , a welder using this process is not considered a Co2 welder . TIG stands for tungsten Inert Gas , so the welder is considered / called a TIG Welder.


If you have a spa that is 240V with 4 wires can you hook an extension cord from a 240V welder to it to see if it works if the cord only has three wires?

No, you should not hook up an extension cord from a 240V welder to a 240V spa with different wire configurations. It is important to match the wire configurations to prevent damage or safety hazards. Additionally, using equipment for unintended purposes can lead to dangerous situations.


What does the term single hand welder mean?

A "single hand welder" is any person welding on a job that is not using their own personal equipment. I.E., welding with a company welder or rented welder until you can afford to buy your own welder.


How long after using Ground Clear can you plant?

You should wait at least 24 hours after using Ground Clear before planting anything.


How can I build a deck on the ground?

To build a deck on the ground, start by clearing the area and leveling the ground. Then, lay down a weed barrier and gravel for drainage. Next, build a frame using pressure-treated lumber and secure it with stakes. Finally, attach decking boards to the frame using screws or nails.


What must be checked before using the 110-volt power plug on a portable welder?

Before using the 110-volt power plug on a portable welder, you should check if the plug is compatible with the power outlet, ensure the wiring is in good condition and properly connected, and verify that the welder's power requirements do not exceed the capacity of the power source.


What should you do when using a ground ambulance to evacuate a litter casualty?

tweet


What can be used to repair an aluminum line other than welding?

the best way to get a good looking/ strong weld on aluminum is using a tig welder it is also possibles with a mig welder but for best results recommend a tig welder with HF


What setting should the sand filter be at when using the the above ground pool cleaner?

It should be on "FILTER"


Were is a good place to ground a car battery?

Grounding a Vehicle BatteryUsually, manufacturers attach the ground cable from the battery to the engine block. I don't change that unless some other factor makes using the manufacturer's ground location impossible, and then I route the ground cable to a manifold bolt within reach of the cable.


What protection should be worn at the welder is working in the area that exceeds to set limits for noise?

The welder should wear hearing protection such as earplugs or earmuffs that are designed to reduce noise levels. It is important to choose the appropriate level of protection based on the noise levels present in the work environment. Additionally, using a combination of earplugs and earmuffs can provide extra protection.


How many volts does a wire feed welder need?

A wire feed welder typically requires a voltage of around 220-240 volts for operation. It is important to check the specifications of the specific welder model you are using to ensure it is compatible with the power supply available.