answersLogoWhite

0

you would spin in a circle

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

What would be the problem if when pressed the brake brake pedal clicks?

nothing it could just be the tail lights coming on.


What is wrong when a clutch pedal is half pressed and at the same time the accelerator is pressed?

if I understand the question you asked correctly, I would say you are in need of a clutch but it might need adjustment but not likely.


Why would a 97 F150 vibrate and then cut off while stoped unless the accelerator is continually pressed?

you might have a bad / or disconnectedidle control valve.


Why would a linear accelerator have no effect on a neutron?

A linear accelerator mainly accelerates charged particles like electrons and protons. Neutrons, as neutral particles, are not affected by electric fields and thus would not be accelerated by a linear accelerator.


How many pedals does an automatic car have?

Only two. Accelerator (gas) and Brake. There MAY be a third "pedal" lever which would engage the emergency brake -- typically on the far right, against the wall. If this is the case, there will not be a hand brake.


What would happen if someone drunk brake fluid?

They would die of kidney failure.


Why would a 1995 Plymouth Neon sometimes not move or rev up when the accelerator is pressed?

automatic transaxle is probably low on fluid or too full. otherwise have a trans shop check er out


What would happen if the brake pads wore out?

Braking would deteriorate and you could damage the rotors.


What would make your mondeo tdci have a flat spot and only when driving at 55 to 65 mph?

Flat spots occur due to several reasons. It could be leaks in the accelerator pump piston or the accelerator pump valves. It can occur when you are accelerating because there is a momentary hesitation from the engine after the pedal is pressed down.


What would cause a hissing noise to come from the brake pedal on a 1990 ranger when it is pressed down to the floor and the brakes barely work?

Vacuum brake booster is defective or the hose going to the booster is leaking.


Why would a 87 300zx idle smooth but when accelerator is pressed it shutters and and then stalls?

i have the same problem. i have good fuel pressure and new filter. it could possibly be related to airflow sensor or vacuum lines.


What would cause a knocking sound underneath when you let off the brake and hit accelerator on a 1999 Toyota Solora?

loose exhaust pipe or muffler is most common