JOHN DEERe all-weather hydrostatic fluid or an equivalent type "F" automatic Transmission Fluid
back of tractor below fuel tank.
Where is the hydraulic fluid drain plug on a John Deere 7410 Tractor
In a 2009 John Deere 6115D tractor, you should check the hydraulic fluid when the hydraulic system is warm, as this allows for more accurate readings. The fluid expands when heated, providing a better indication of the fluid level during normal operating conditions. It's best to run the tractor for a short period before checking the level to ensure the fluid is circulating. Always consult the owner's manual for specific guidelines related to your tractor model.
To check the hydraulic fluid level on a John Deere 4310 tractor, locate the hydraulic fluid reservoir, which is typically found near the rear of the tractor. Remove the cap from the reservoir and use the dipstick, if equipped, to check the fluid level. The fluid should be within the recommended range marked on the dipstick or the reservoir. Ensure the tractor is on a level surface and that the engine is turned off during this process for an accurate reading.
if you are referring to the sight glass when the tractor is running the fluid will not be seen in the glass because it will be in all the hydraulic lines and pumps
you can not fill the transmission on a JD 155c, it is sealed.
Go to your John Deere dealer and pay big bucks for their hydrostatic fluid or go almost anywhere else and buy a good quality hydraulic fluid.
next to were you fill your gas under seat, left hand side
Although I can't say for certain, it may take Hy-Gard.
how do i check the hydro transmisson fluid on a stx38
A 2155 w/o 4wd holds 50 qts of hydraulic fluid. A 4wd takes 53.2 qts.
any hydraulic transmission oil such as Hy-tran Case IH or Hy-Gard John Deere