0
What else can I help you with?
How can you remove stuck brake rotors on a 1987 Pontiac Bonneville?
Remove set screw. Then tap the rotor with a hammer. The rotor should break free. It has just rusted itself to the axle, due to condensation.
Why would the ignition key not work in 2000 Pontiac Montana Van I can jump the starter with a screw driver and it will start?
try not stealing a car.
How do you take a rotor off a 1999 Daewoo is it the center nut or the screw on the rotor?
The center nut is for the hub assembly. You need to remove the screws on the rotor. The screws might be stuck to the rotor when you try to take it out. If this is the case, be careful when you use the screwdriver. You might round out the screw head. When the screw is hard to remove, I usually use a 1/4" socket wrench, 1/4" socket, and screwdriver bit. The screwdriver bit will fit inside the 1/4" socket. This gives you extra torque and won't round out the screw as a screwdriver might do. Once the screws are out, the rotor should come right off.
Is screw force the same as screw torque?
No, screw force and screw torque are not the same. Screw force refers to the axial force applied along the axis of the screw, while screw torque refers to the rotational force needed to tighten or loosen the screw. Torque is calculated by multiplying the force applied and the distance from the axis of rotation.
How to replace 2002 Pontiac Montana Battery?
To replace the 2002 Pontiac Montana battery disconnect both the battery cables from the terminals. Then, remove the screw to the battery holder, located behind the battery. Slide the battery slightly to the front of the vehicle and lift up. Reverse this procedure to put in a new battery.
Where do you put the refrigerant in a 1999 Pontiac Montana?
open the hood look straight down,there will be a valve with a screw on cap that is usually blue it is connected directly to the a/c pump
How do you find torque of screw Jack?
Screw Jack torque formula: T=9550*P/R T: torque , N.m P: power , KW R: rpm Screw Jack Can be operated by electrically or manually.
Where is the torque screw on my chevy truck?
Give us more info like the year, model, engine and define "torque screw".
What was the insparation of the helicopter?
Leonardo di Vinci drew a device that resembled a helicopter and the rotor looked like a large screw. Later in the 1900's, some people tried built helicopters with a large rotor that tapered to a point like a screw. This was one inspiration. They had the idea that the screw-rotor could screw up into the air.
Where is the bleed screw on sunfire Pontiac?
On the thermal housing
How do you tighten drum brakes on 2001 Pontiac Montana?
To tighten the drum brakes on a 2001 Pontiac Montana, first, remove the rear wheel and tire to access the brake drum. Locate the adjuster screw through the access hole in the drum or remove the drum if necessary. Use a brake spoon or a flathead screwdriver to turn the adjuster screw clockwise to tighten the brake shoes until they lightly contact the drum. Finally, reassemble the components, ensuring everything is properly secured before testing the brakes.
How do you remove the rotor to access the ignition coil for the Honda Civic?
a little 8 mill screw on bottom of rotor into dist shaft
