0
Usually interior walls are usually a 2x4 3 1/2 inches thick with 1/2 drywall on each side so they are 4 1/2 inch thick. Exterior walls are a 2x4 3 1/2 inches thick with 1/2 drywall on the interior and then the exterior covering which can vary in thickness depending on type. In countries that use 'mm' as their measurement, exterior wall 270mm (110mm Brick, 50 Cavity, 110mm Brick/Stud Wood Framing) and interior walls 110mm (Brick/Stud Wood Framing).
Add your answer:
Earn +20 pts
How do you decide the thickness of brick wall?
Finished wall thickness X 20 = wall height
How do I Find wall thickness of tube?
wall thickness of pipe is (OD - ID) /2
What is the weight of mild steel pipe OD 40mm and wall thickness 4mm?
=3.14 * (Diameter of pipe in Mtr. - wall thickness in Mtr. ) * Wall Thickness in Mtr. * 7850
The maximum thickness of a reinforced concrete wall?
The maximum thickness of a reinforced concrete wall is 203 mm.
What is the wall thickness of 500mm pipe?
the wall thickness of sch 40 - 500mm dia pipe is 15mm or 16mm.
What is the nominal wall thickness in a shell or head of vessels?
technically nominal wall thickness refers to pipe wall thickness (average)..if you are referring to shell/hull/fore part of a vessel, the thickness varies depending of type, size, deadweight of the vessel
What is the outside diameter of a 54 inch reinforced concrete pipe?
It could be 65" (b wall - 5.5" wall thickness), or 66.5" (c wall - 6.25" wall thickness).
Uneven cooling?
When the wall thickness of the injection molding parts is not uniform, the thick part of the wall cools more slowly than the thin part, so the thick part of the wall produces shrinkage holes.It is theoretically difficult to eliminate shrinkage caused by uneven wall thickness, so uniform wall thickness should be made when designing parts. That is, the focus is on reducing the variation in wall thickness.
Wall plate thickness of LPG cylinder?
minimum wall thickness of cylinder of water capacity 33.3 liter is 2.5 mm
What is the thickness of regular aluminum foil?
Regular aluminum foil typically has a thickness of around 0.0004 inches (0.01mm).
How can you calculate the ID of a pipe?
The ID of a pipe (inner diameter) can be calculated by subtracting the pipe's wall thickness from its outside diameter. The formula is ID = OD - 2*WT, where ID is the inner diameter, OD is the outer diameter, and WT is the wall thickness of the pipe.
What is the normal thickness of the uterine wall?
about 5cm
