Exhaust pipe to manifold nuts, 15 to 22 ft-lbs.
exhaust manifold is where exhaust pipe hooks to engine!
The torque settings for the exhaust manifold lower heater shield bolts for?æa d16y5 is 96 in - lbs. The oil pan drain plug torque settings is 29 and exhaust pipe to manifold nuts is 25.?æ
its right after the exaust manifold.the exhaust manifold is on each side of the motor.it runs from there to uder the car or truck.it connects the manifold and the begining of the pipe that runs to your muffler.
It should be about 45 ftlb
Exhaust mainfold to cylinder head 22 ft-lbsExhaust manifold to header pipe 33 ft-lbsExhaust manifold bracket bolts 20 ft-lbs
I just changed the one on my wife's 1998 blazer last week. It is located on the passenger side in the exhaust manifold. I used a open end wrench with a pipe to break it free. Hope this helps.
start at the exhaust manifold and follow the pipe or if it has dual exhaust follow both, you will see it.
it is under a coolant pipe that is under lower intake manifold
All oxygen sensors on all vehicles are on either the exhaust manifold or the upper end of the head-pipe.
Passenger side exhaust pipe directly after the exhaust manifold.
The o2 sensors are located in the exhaust system either on the exhaust manifold or the exhaust pipe itself. Most of them are in front of the convertor.
Assuming you mean bank 2 sensor 1, it would be the first O2 sensor located in the header pipe after the passenger side exhaust manifold.