Want this question answered?
Be notified when an answer is posted
my washer keep on by passing the spin cycle and will not drain out the water.
A Maytag washer may not spin due to issues with the motor, belt, lid switch, or drive pulley. Check these components to determine the root cause of the problem and address it accordingly. It may be helpful to consult the washer's manual or a professional technician for further assistance.
kenmore washer 3 110.24944301 water run during the spin cycle what part would i be looking at to fix this
If the soap is spilling out of the washer, then stop the wash cycle, set it to spin, and let it spin the soapy water out. Then reset the washer for a full wash and rinse cycle to get out all of the soap. If you set it for a rinse cycle only, it won't remove all of the suds, resulting in dingy laundry.
A blocked drain.
To prevent your washer agitator from banging loudly during the spin cycle, try to balance the load inside the machine by redistributing the clothes. Make sure the washer is level on the ground to avoid any vibrations. Additionally, you can check that the agitator isn't loose or damaged, as this could also cause the noise.
Press Power on button, do NOT select a cycle, Press and hold the "Spin Sense" Button then spin shows up in the screen, select spin speen and time will show up in the frame select "start" and you're go to go.
To prevent your front loader washer machine from walking during the spin cycle, make sure the machine is level by adjusting its feet. Ensure the load inside the washer is balanced and distributed evenly to avoid vibrations that can cause the movement. Additionally, consider placing an anti-vibration pad or mat under the machine to help absorb excess movement.
A big red alien comes down from the sky and zaps your washer and then it spin drys!
Check that both water connections (hot and cold) are connected and on. If there's no cold water supply, the washer will just hum when it tries to do a cold water rinse.
The clothes may come out soaking wet if the spin cycle is not working correctly or if the load is too heavy, causing the machine to be unbalanced. It could also be due to a clogged drain pump or a problem with the water level sensor.
If a Maytag washer fills with water but does not agitate it could a problem with the switch in the lid. There is a switch that locks the lid down during agitation and spinning. The magnet could be defective.