0
What is the name of the bar that hold the engine under the car?
Wiki User
∙ 14y ago
It is called the engine cradle, 4 main bolts hold the cradle to the sub-frame. An easy way to pull an engine is to drop the cradle to the ground, AFTER unhooking ALL the wiring and hoses. This should not be attempted by a nonprofessional.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
How do you edit forumotion.com website tab bar name?
Go to Admin Panel > General Settings > Under Forum Promotion is Search Engine. There :D
Where are the glow plugs located on an 06 vauxhall vectra?
at the back of the engine, under the bar near the top of engine
In a rocket what is an engine mount?
In a model rocket that uses engines, there is an engine mount. The engine mount is located inside the body tube in the bottom where the engine goes. It usually consists of a small tube, two rings that connect it to the body tube, and a metal bar to hold the engine in the tube. Its job is to house the engine and hold it in place for a flight. glad to help, Uujjee
In the assets page what is the bar under your dogs name?
It tells how much it likes you.
How do you become big on Movie Star Planet?
u click ur name and hold space bar then u drag ur name nd clik it nd hold spacebar again
How do you remove the oil injection on Johnson outboard engine?
The answer to this question is on web under (johnson vro50) type in search bar
When changing a transmission on a 1997 Pontiac Sunfire 2.2 is it easier to remove the motor or go through the bottom?
Its easier from the bottom (just make sure you use a engine support bar to hold the engine)
Meaning of under bar in bar?
it is a storage area in a bar.
What was the name of the bar James Buchanan was admitted to in 1812?
Buchanan read law under a lawyer in Lancaster , PA where he lived. I presume he was admitted to the Pennsylvania bar.
How do you remove a 1997 Ford Escort transmission?
That depends on whether you have a manual 5 speed or an automatic. On both you have to support the engine from above since 2 of the 3 mounts are on the transmission. Disconnect all the electrical connections. Remove the bolts and nuts that hold the left hand engine mount. Remove the upper front and upper rear bolts that hold the trans. to the engine. Remove the starter motor. Remove the drive axles. Drain the transaxle fluid Remove the crossmember. Unbolt the gear shift rod from the input shaft of the transmission. Remove the nut that holds the gear shift bar to the transaxle. Then slide the bar off the stud. Remove the clutch slave cylinder. Remove the 2 lower bolts that hold the transaxle to the engine. Put a transmission jack under the transmission Remove the catalytic converter. With the transmission supported well, remove the last 3 bolts that hold the engine to the transmission. Carefully lower the transaxle and slide it from the engine.
How do you know if you need to replace the link bushings on a front sway bar of your 1991 Mercury Cougar LS?
get under vehicle with out jacking vehicle off the ground hold sway bar with hands try to move bar sideways if bar slides sideways in bushings, the bushings are shot not a hard job to repair
How do you hold on to stuff in happy wheels?
hold on to it by holding space bar also grab by space bar
