0
What is the meaning behind a yellow bumper sticker with a small black bat flying in the right hand corner?
Wiki User
∙ 12y ago
The driver is a caver. Someone who enjoys exploring wild caves. Please locate the local caver group (Grotto) if you are interesting in learning more.
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
What is the best way to remove bumper stickers on a car?
The best way to remove bumper stickers on a car are Find a powerful hair dryer or rent a heat gun, Hold the hair dryer about 6" from the sticker and blow heat directly on the sticker for a minute or two, Starting at a corner, with your fingernail (or razor blade to grab the edge only) peel back a corner.
Where is the horn 1998 Mercury Tracer?
behind plastic bumper on Right corner below marker lighting
How do i delete bumper stickers on facebook?
Click on the bumper sticker. When you click on it there should be a gray bar on top of the new screen. On one of the buttons on the gray bar it says "my stickers" . Click on that button and all of your stickers will show up. Click the "x" box in the corner of the sticker you want to delete, then make sure to click "save changes"
Where is the overhead console temp sensor on a 1997 ford explorer?
Under the driver's side front corner of the car, behind the bumper.
Where is the horn located on 2003 Ford Fiesta?
The horn is usually located behind the front left wheel arch/bumper corner.
How do you remove bumper stickers?
There are several methods for removing bumper stickers from your car. 1) A wet rag and boiling water. Affix the rag over the sticker. Pour boiling water over rag repeatedly. Let it soak for at least one minute. Using your fingers, peel the sticker off carefully, beginning at a corner. If it doesn't come off easily, repeat the application of the rag and hot water. 2) In a spray bottle of water, mix small amounts of either dish soap or rubbing alcohol. (Or both.) Spray over the entire bumper sticker and let it soak for ten minutes. Again, peel off from a corner. 3) Soak a rag in vinegar and affix it over the bumper sticker for five minutes. Peel off from a corner. 4) Use a blow dryer, set on low hear, to warm up the whole area of the bumper sticker for at least half a minute. Keep the dryer about 6 inches from the surface. Peel at a corner whilecontinuing to apply the heat. 5) Put some WD-40 or lighter fluid on a rag and rub the rag on the edges of the bumper sticker. If these methods only loosen up the sticker without getting it all off, peel off the sticker using a rubber or plastic edge such as a credit card, or spatula. Never use a metal edge as it might scratch your car. Wipe any remaining glue with a rag and some alcohol. There are also commercial products that can remove glue that might be helpful such as Goo Gone. If the surface appears faded, use car polish or car wax. Remember, this is a project best suited for a warm day.
Where in the engine bay of a Renault espace is the horn located?
its not in the engine bay. it can normally be found behind the bumper on the left hand corner in front of the wheel
Where is the horn in a 1996 Mazda Protege?
Just behind the right corner of the front bumper. You have to remove the black cover under the car to see it. Mazda hide it pretty well.
Where do the stickers go on Ohio license plates?
The county number sticker goes in the lower left corner. The expiration year and month sticker is placed in the lower right hand corner.
Where is the air conditioner drier located in a 2002 Kia Sedona?
The drier is partially behind the front bumper under the grill; lift your hood. It is on the left side at the bottom corner of the rad.
How do you replace the headlamps on a 1992 Prelude?
Open hood Remove front bumper 2 10mm bolts holding the bumper to each fender at each corner of the corner. 5 phillips head screws holding the bumper to bumper support at the top of the bumper. undo all the screws/bolts holding the bumper to the under splash shiled. undo the turno/bumber signal bulb signal bulnbs 2 on each side 12mm bolts holding the bumper support to the radiatoror suppport. then behind the battery/cruise control: is 1 10/12mm nut holding the stud to the radiatory support, then you take it off, and install in th reverse order Remove headlight.
How do you remove headlight in 1995 prelude?
Open hood Remove front bumper 2 10mm bolts holding the bumper to each fender at each corner of the corner. 5 phillips head screws holding the bumper to bumper support at the top of the bumper. undo all the screws/bolts holding the bumper to the under splash shiled. undo the turno/bumber signal bulb signal bulnbs 2 on each side 12mm bolts holding the bumper support to the radiatoror suppport. then behind the battery/cruise control: is 1 10/12mm nut holding the stud to the radiatory support, then you take it off, and install in th reverse order Remove headlight.
