To prevent the engine from being started while the transmission is any gear other than park or neutral.
Wiki User
∙ 2016-07-08 13:37:12Wiki User
∙ 2016-07-08 17:18:39To not allow the vehicle to start unless the transmission is in park or neutral (automatic) or the clutch pedal depressed (standard transmission).
to shut off the engine if the operator is thrown overboard
PWC's (personal water craft) Ignition Safety Switch is used to shut down the Engine if the Operator loses control or thrown off of the water craft.
The ignition timing marks can be found on the main pulley. The timing marks will be scattered on the outside edge of the pulley.
I am not sure what causes this, but I have had times when my ignition key would not turn. The solution to the main problem is to turn the steering wheel slightly. This usually allows the ignition key to turn.
Its a fuel cut switch for theft deturrent or a main power cutoff to preserve batteries in race cars for example.
To kill the engine if the operator is thrown out
to shut off the engine if the operator is thrown overboard
to shut off the engine if the operator is thrown overboard
PWC's (personal water craft) Ignition Safety Switch is used to shut down the Engine if the Operator loses control or thrown off of the water craft.
To not allow the engine to start unless the shift is in park or neutral in an automatic or the clutch is depressed in a standard transmission.
To turn off the engine of a PWC once the Driver is thrown overboard or injured.
to shut off the engine if the operator is thrown overboard
The Ford Neutral Safety Switch is an electronic part with the main function to stop the vehicle from getting started while in gear. The truck will not start when the switch is faulty.
A 2000 Toyota Camry has an ignition switch fuse location in the main fuse panel. It helps protect the switch and the rest of the ignition system from surges.
an ignition switch or starter is a switch that activates the main electrical systems of a vehicle. This normally powers the start motor that turns the engine in the starting up process. . Most vehicles do not have an ignition switch anymore the key in the cylinder acts as the "switch"
To replace an ignition switch on a 2000 Chevy Blazer remove the lower steering column and dash. Locate the ignition switch and pull the end-clip off the main harness. Remove the mounting screws from the ignition cylinder and replace the unit.
They are worn for safety, comfort, and modesty