0
Add your answer:
Earn +20 pts
Do you have too remove the rods and rocker arms on a Chevy 350 before you take off the heads?
PUSH rods and rocker arms... yes.
How do you install rocker arms on Chevy 350 correctly?
How do I change from standard rockers an push rods to roler rockers
Chevy 350 how to replace push rods?
Pull the valve covers off. loosen the rocker arms with out taking them all the way off. then you can turn the rocker arms to pull the push rods out. replace push rods, and tighten rocker arms back down and put valve covers back on
What should i remember when removing heads on 350 Chevy?
Which side they came from, where the push rods came from and if you remove the rockers remember which rocker went where
Can the push rods on a Chevy 350 prevent the motor starting if the rods are to tight?
Yes. If the valves (rocker arms/push rods) are adjusted too tight, the valves will hang open instead of closing. This will result in a loss of compression at the very least. It can also prevent the engine from pulling in air/fuel as well.
How do you clean Chevy 350 push rods?
Run a small piece of wire down through them and clean them with carb cleaner. Then blow them out with air.
Are the rocker arms ajustable on a 1999 Chevy 350?
YES they are.
Where are the casting numbers Chevy 350 head?
Under the rocker cover.
What does bent rods sound like on a 350 engine?
If you are talking about the PISTON RODS then they will not make any noise. The engine will just wear the pistons and cylinder walls until you have a problem with oil comsupition. If the push rods or bent then you will have a engine miss and rocker arm noise in the valve covers/ clatting noise.
Are Chevy 305 and 350 connecting rods the same?
yes
You just put in a new 350 you have good oil pressure to the gauge but no oil to the rocker arms why?
A spun cam bearing, or just bad cam bearings period. Push rods stoped up, Need cleaned.
Where do you pour the oil in a Chevy 350?
Look for a plug or cap in one of the rocker covers.
