answersLogoWhite

0


Best Answer

The blend door actuator's function is to blend the outside air/heat or outside air/ air cond to get the desired temperature out of the unit.

It also switches between heat and air conditioning modes.

User Avatar

Wiki User

16y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What is the function of the blendor acuator?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

89 Ford F-150 ignition actuator arm removal?

How do you remove acuator switch


Where is the camshaft position-acuator on Chevy hhr 2008?

Replacement of a 2008 Chvy Camshaft Sensor


How do you replace the heater cable for hot to cold in a 1998 mercury mountainer?

it does not have cable, it is vaccuum and acuator motor driven


Where is the blend door actuator located in a 1998 Toyota Camry?

where is the blend door machanism (acuator) located in my 1998 toyota camryalso how to fix


Acuator valve replacement for heater 2005 Chevy venture?

my heater fan in front of my 2004 chevy venture van wont work


Where can you get the blue plastic clip that goes on the end of the power acuator in the tailgate of a 2000 s15 jimmy?

only place i found one was junk yard


Will a turbo 400 replace a 4L60E in a 1994 Chevy Z71 4x4?

Yes it will bolt up but you will have problems making the front end acuator work


The brake lights on my Chrysler Cirrus remain on when the car is off. How do I fix this?

on the brake pedal bracket there is an acuator it may be adjustable or you may need to replace it


Where is the temp blend door acuator located on a 2000 chevy blazer?

On the HVAC box behind the dash assembly. Unfortunately, the dash has to be removed to gain access to it.


Why does the driver side of the car put out heat and passenger side put out cold air on a 1997 Cadillac DeVille?

passenger side temp acuator has gone bad


Where is left hand door acuator located in 2004 gmc Yukon?

you have to take off the door panel it is made of hard plastic it will have some wires going to it and will be close to your manual door lock


Why does the heater just blow cold air?

one because it is set on air only .. u need to shift it to warm first the RED mark...Secondly your heater wire must have come loose in the electricals. you should check out blendor store.com we had the same problem with our jeep, very helpful.