0
What else can I help you with?
Where is the shift lock solenoid located on 2007 dodge charger?
It is inside the shifter assembly.It is inside the shifter assembly.
Why does the transmission shifter lock how can it be fix?
install transmission shifter assembly
What is the proper name for the stick shifter assembly?
Gear shifter or manual transmission.
What is the clamp called that hold the shifter up into the dash?
The clamp that holds the shifter up into the dash is called a shifter cable bracket. It is designed to secure the shifter cable in place and keep it connected to the shifter assembly.
1996 Town car shifter pin?
broken shifter on colum how do I locate the shifter pin
Will replacing the entire shifter assembly on your C230 cost a fortune?
i took it to my reputable mechanic and in total it's going to run near a thousand dollars. the shifter assembly itself is over 500!
How long is the shifter cable on a 91 town car exec?
How long is the shifter cable on a Lincoln Town Car Exc
How do you change the automatic transmission shifter on a 98 altima?
First remove the center console assembly by removing the five screws that are holding it down two are by the rear bottom sides of the center console two are hidden under the wood grain bezel around the shifter assembly just pry that up off of there and the last one is in the cup holder (make sure you have the parking brake set) once you have the center console removed you're going to want to remove the shifter linkage cable by prying up on the metal clip holding it down but before you do that you will have to pry up on the black bezel that has the gear indicators on it to gain access to the metal n shaped clip that is holding down the shifter linkage cable then at the end of the cable is a nut that attaches it to the shifter lever remove that nut while the shifter lever is in park Then just pull the cable towards the front of the car and lift up on it to get it out of the way next remove the electrical connector attached to the shifter assembly by squeezing the tab on it and lifting it out next remove the shift interlock cable by squeezing the white tabs and popping it off then jack up the car and put it on jack stands or drive it up on a ramp get under the car and remove the heat shield that is directly above the catalytic converter by removing the five bolts holding it in place once you have that off you will see the under side of the shifter assembly unbolt the two nuts that are holding it down to the body of the car next get back inside the car and remove the two other nuts that are holding down the shifter assembly and there you have it if you have any trouble or just couldn't understand any part of my instructions then just email me at RWDrift350@gmail.com and I will go over it with you
What is a floor shifter?
a part of a car
Does the shifter assembly from a 1993 Lincoln Mark viii fit a 1996?
It should.
What are the parts for a shifter assembly on a 2007 dodge charger?
the shifter is controlled by 2 cables on the newer cars, there is no manual parts like on the older vehicles.
Where can you get the diagram of the Chevy HHR shifter assembly?
This problem is not a new one. By the way, if you're having the key stuck issue, or if the shifter moves without pushing anything, buy a new shifter assembly. Official TSB and Recall Thread - Page 14 - Chevy HHR Network (Use the link below.)
